Abstract:Water is essential for the survival of all living things; however, its extensive use in agriculture, high-tech manufacturing, energy production, and the rapid development of the chemical and petroleum industries has led to significant contamination, making water pollution a major concern today. Ammonia is one of the most harmful contaminants present in water, posing significant environmental and health risks that require appropriate remediation methods. To remove ammonia from contaminated water, we employ Carbon Nanotubes (CNTs) and Activated Carbon (AC). To ensure appropriate metal impregnation on the adsorbents, Fe, Al, Ag, and Cu were impregnated into both CNT and AC, followed by extensive characterization using Thermogravimetric Analysis (TGA), Scanning Electron Microscopy (SEM), and Energy Dispersive X-rays (EDX). To optimize ammonia removal from water, several parameters were adjusted, including pH, dose amount, contact time, shaking speed, and temperature. Astonishingly, the highest removal efficiency of 40% was achieved with a 1 g dosage at pH 10.5 and 200 RPM, while silver oxide had a lower removal rate of 10% under the same conditions. Temperature additionally had a significant impact, with removal percentages reaching 40% at 70 °C as compared to 21.5% at 25 °C. Adsorption isotherms were used to analyze the experimental data, along with Langmuir and Freundlich's models. Notably, Langmuir produced superior curve fitting, resulting in a correlation factor close to one. Furthermore, kinetic modeling was carried out with 2nd-order and pseudo-2nd-order equations, with the latter responding better according to curve analysis. Because the ammonia removal rate was low, this study indicates the feasibility of implementing an adsorption technique using CNT and AC as a pre-treatment method for this purpose. This approach has the potential for future optimization and deployment in tackling water contamination concerns effectively.

An alternative hydrothermal route to amorphous carbon nanotubes for treatment of organic pollutants in water

Boosting the Adsorption and Removal of Dye from Water by COOH-functionalized Carbon Nanotubes

Enhanced Adsorptive Removal of Methyl Orange and Methylene Blue from Aqueous Solution by Alkali-Activated Multiwalled Carbon Nanotubes

Facile preparation of water-soluble hyperbranched polyamine functionalized multiwalled carbon nanotubes for high-efficiency organic dye removal from aqueous solution

Carbon Nanoparticles for Cationic Dye (methylene Blue) Removal from Aqueous Solution

Efficient Removal of Hazardous P-Nitroaniline from Wastewater by Using Surface-Activated and Modified Multiwalled Carbon Nanotubes with Mesostructure

Robust and Highly Efficient Free‐Standing Carbonaceous Nanofiber Membranes for Water Purification

A New Type of Activated Carbon Fibre Supported Titanate Nanotubes for High-Capacity Adsorption and Degradation of Methylene Blue

Are carbon nanotubes promising adsorbents for water treatment ?

In situ growth of HKUST-1 on electrospun polyacrylonitrile nanofibers/regenerated cellulose aerogel for efficient methylene blue adsorption

Adsorptive removal of benzene and toluene from aqueous solutions by oxygen-functionalized multi-walled carbon nanotubes derived from rice husk waste: A comparative study

Halloysite nanotube@carbon with rich carboxyl groups as a multifunctional adsorbent for the efficient removal of cationic Pb(II), anionic Cr(VI) and methylene blue (MB)

Enhanced Adsorption of Methylene Blue Dye on Functionalized Multi-Walled Carbon Nanotubes

Preparation of Regenerable Granular Carbon Nanotubes by a Simple Heating-Filtration Method for Efficient Removal of Typical Pharmaceuticals

Removal of anionic and cationic dyes from wastewater by adsorption using multiwall carbon nanotubes

Super-adsorptive and photo-regenerable carbon nanotube based membrane for highly efficient water purification

A highly efficient modified nano-activated carbon adsorbent for separation of ammonia from water: Experimental and kinetics elucidations

Highly carboxylate functionalized halloysite nanotube as an efficient and recyclable adsorbent for methylene blue

Preparation of activated carbon from waste cation exchange resin and its application in wastewater treatment

Multi-Walled Carbon Nanotubes Functionalized with Hydroxamic Acid Derivatives for the Removal of Lead from Wastewater: Kinetics, Isotherm, and Thermodynamic Studies

Preparation of Amine Functionalized Carbon Nanotubes Via a Bioinspired Strategy and Their Application in Cu2+ Removal