Rapid emuision polymerization of poly (2, 3-dimethylaniline) initiated by APS/Fe2+ composite oxidants and its performances

Li Ma,Shujuan Wei,Mengyun Gan,Feifei Chen,Nan Tian,Jun Zeng
DOI: https://doi.org/10.3724/SP.J.1105.2013.12337
2013-01-01
Acta Polymerica Sinica
Abstract:Poly (2, 3-dimethylaniline) (P (2, 3-DMA)) was synthesized by a rapid emulsion polymerization using ammonium peroxydisulfate and ferrous ion (APS/Fe) as composite oxidants. The effect of Fe2+ on the rate of polymerization of 2, 3-dimethylaniline (2, 3-DMA) was discussed by open circuit potential (OCP) curves, and the molar ratio of APS and Fe2+ and the amount of composite oxidant were optimized by cyclic voltammetry and Tafel curves. And the characterization results of electrochemical properties of P(2, 3-DMA) were proved by contrast analysis of infrared spectroscopy (FTIR) and X-ray diffraction (XRD). The experimental results showed that main infrared absorption peaks of P(2, 3-DMA) which was synthesized by the composite oxidant exhibited red-shift. The phenomenon revealed that the structure of products was relatively complete and the electron deloalization increased. The optimal properties of P (2, 3-DMA) were achieved when the molar ratio of APS to Fe 2+ was 10: 1, the molar ratio of APS to 2, 3-DMA was 3: 1. The open-circuit potential measurements indicated that the rate of polymerization of 2, 3-DMA with the aid of Fe had a substantial increase. The P(2, 3-DMA) with higher yield, better electrochemical and crystal properties have been prepared by composite oxidant APS/Fe2+.
What problem does this paper attempt to address?