Abstract:Solutions containing hydroxy-SiAl(HSA) oligocations were prepared by two procedures: (1) treatment of a mixture of silicic acid, which was prepared by dispersing silica sol in an ultrasonic generator, and AlCl3 with aqueous NaOH, followed by aging of the product and (2) preliminary preparation and aging of hydroxy-Al13 oligocations followed by reaction of the latter with silicic acid. Exchange of Na-montmorillonite with HSA oligocations yielded pillared clays (designated as SiAl-PILC obtained using method 1, and GSiAl-PILC obtained using method 2) showing mixed maximum d(001) values of 2.65 and 1.90 nm for air-dried samples and maximum surface areas of approximately 267 m2/g after outgassing at 200-degrees-C/101 kPa. Elemental analysis showed a gradual increase in the Si/Al ratio in the intercalated HSA oligocations with increasing Si/Al ratio in the pillaring solution. The pillaring structure, thermal stability, and surface acidity of the pillared clay products have been determined using Al-27-NMR, X-ray diffraction (XRD), XPS, DTA, IR, and temperature-programmed desorption (TPD) measurements. The results suggest that the thermal stability of the pillared clays was improved by incorporating silica. Hydroxy-SiAl pillared clays show sharply higher concentrations of strong acid sites, especially Bronsted acid sites, compared with reference Al-PILC obtained by pillaring with hydroxy-Al13 oligocations. This increased acidity is probably due to the presence of acidic, surface silanol groups in the HSA oligocations. The cracking of cumene and the disproportionation and alkylation of 1,2,4-trimethylbenzene were carried out in a pulse reaction system at 400-degrees-C over the pillared clay catalysts. Incorporating silica into an alumina pillar increased the cracking activity of cumene and the activity and selectivity for the disproportionation of 1,2,4-trimethylbenzene compared to those observed for Al-PILC.

Enhanced Activity over Alkyl/Aryl Functionalized Porous Pillared-Zirconium Phosphates in Liquid-Phase Reaction

Robust Mg(Ca)Zr-Doped Acid-Base Bifunctional Mesoporous Silica and Their Applications in the Deacetalization-Knoevenagel Reaction.

Preparation and catalytic application of phenylsulfonic acid functionalized porous phosphate heterostructure materials

Phosphorous Modified High Silica ZSM-5 Spherical Catalyst and Its Reaction on Methanol to Propylene

Surface Functionalization of Mesoporous Silica Sba-15 by Liquid-Phase Grafting of Zirconium Phosphate

Alumina-pillared Α-Zirconium Phosphate Prepared by In-Situ Polymerization Method

Pore Morphology-Controlled Preparation of ZrO2-based Hybrid Catalysts Functionalized by Both Organosilica Moieties and Keggin-type Heteropoly Acid for the Synthesis of Levulinate Esters

Fabrication of Monodisperse Porous Zirconia Microspheres and Their Phosphorylation for Friedel-Crafts Alkylation of Indoles.

Preparation and catalytic properties of chromia-pillared α-zirconium phosphate

Synthesis and Functionalization of Mesoporous Zirconium(Iv) Phosphate-Phenylphosphonate with Small Mesopores

An atom-economic reaction for synthesis of 1-phenoxy-2-propanol over Al2O3/MgO

Synthesis of Mixed Alumina Silica Pillared Zirconium Phosphate and Its Catalytic Performance in Epoxidation of Soyate

Silica-based mixed oxide pillared layered α-zirconium phosphates

Palladium-doped hierarchical ZSM-5 for catalytic selective oxidation of allylic and benzylic alcohols

Preparation and Properties of Zirconia-Pillared Zirconium Phosphate and Phenylphosphonate

Catalytic Activities and Properties of Sulfated Zirconia Supported on Mesostructured Γ-Al2o3

Studies on preparation and selective oxidation activities of chromia-pillared zirconium phenylphosphonate

A highly active and stable organic-inorganic combined solid acid for the transesterification of glycerol under mild conditions

One-Step Hydrogenation/Esterification Activity Enhancement over Bifunctional Mesoporous Organic–Inorganic Hybrid Silicas

Preparation and Characterization of Hydroxysilicoaluminum Pillared Clays

Self-assembly synthesis of a high-content sulfonic acid group functionalized ordered mesoporous polymer-based solid as a stable and highly active acid catalyst