Effect of Salt Concentration on the Conformation and Friction Behaviour of DNA

Mian Wang,Yu Tian,Shuxun Cui,Linmao Qian
DOI: https://doi.org/10.1016/j.colsurfa.2013.08.002
IF: 5.518
2013-01-01
Colloids and Surfaces A Physicochemical and Engineering Aspects
Abstract:Double-stranded DNA films (200 bp) were prepared on 3-aminopropyltriethoxy-silane (APS)-modified mica surfaces in the NaCl solution with concentration ranging from 0.001 to 0.1 M. By using an atomic force microscope, the force-distance curve and friction behaviour of each DNA film was studied in the NaCl solution that was used in the sample preparation. When the concentration of NaCl solution decreased from 0.1 to 0.001 M, the range of non-linear repulsion on DNA films increased from 8.6 to 29.1 nm, which suggested that lower salt concentration likely resulted in more extended DNA molecules. At the same time, the friction force on DNA films increased by 190% under a normal load of 2.5 nN, which was attributed to the conformation changes in the DNA molecules induced by the electrolyte ions. Therefore, low salt concentration is more conducive to the sequencing process, since it can not only make DNA molecules easier to reach into nanopore through extended conformation, but also reduce the passage rate by high friction. The results have important implications for the development of the third-generation sequencing technique based on nanopore. (C) 2013 Elsevier B.V. All rights reserved.
What problem does this paper attempt to address?