Abstract:The mandate assigned by the European Union to the Community Reference Laboratory for residues at the Istituto Superiore di Sanità covers, among other things, the assessment of trace elements in living animals as well as their products. To better protect the health of the consumer, this task aims in particular at harmonizing the procedures in use at the National Reference Laboratories (NRLs) for residues of the Member States for such determinations as well as at developing new approaches wherever the need arises. In this context an investigation was undertaken to appraise the average levels of a number of key elements in several types of honey with special regard to the influence of the various processing steps. Instrumental methods of election for the analysis of this matrix turned out to be inductively coupled plasma atomic emission spectrometry (ICP-AES) and inductively coupled plasma mass spectrometry (ICP-MS) depending on the actual concentrations of the elements of interest. Dissolution of the samples for suitable presentation to the analytical systems could be easily achieved by gentle heating at ca. 50 degrees C, sonication and addition of high-purity water. The ranges ascertained are as follows (in ng g(-1)): As, <0.50-0.70; Cd, <0.50-0.74; Cr, 1.03-3.93; Cu, 144-216; Fe, 191-651; Mn, 223-580; Ni, 17-49; Pb, 3.20-186; Pt, <0.50; Sn, <4-27; V, 1.22-1.94; and Zn, 565-1144. As a rule, concentrations of elements in honey from different beehives were similar. A few exceptions were noted for As, Cu, Fe, Ni and Zn. On the other hand, although data obtained with different analytical approaches for the same types of honey and beehive were generally in good agreement, yet some inconsistencies occurred, as in the case of Cu in freshly collected, extracted and ripened honey, Ni in extracted honey and Fe in ripened honey. These could not be traced back to specific procedural facts; rather, they should be ascribed to the inherent heterogeneity of the raw material. The experience gained with this exploratory study will be exploited to set up wider surveys and to plan the preparation of a new certified reference material in a matrix of honey to the benefit of NRLs for residues.

Evaluation of measurement uncertainty in EA–IRMS: for determination of δ 13 C value and C-4 plant sugar content in adulterated honey

Isotope Ratio Mass Spectrometry Coupled to Element Analyzer and Liquid Chromatography to Identify Commercial Honeys of Various Botanical Types

Authenticity Determination of Honeys with Non-Extractable Proteins by Means of Elemental Analyzer (EA) and Liquid Chromatography (LC) Coupled to Isotope Ratio Mass Spectroscopy (IRMS).

Uncertainties Estimation for Determination of 10 Elements in Northeastern China Black Bee Honey by Icp-Ms

Using sensor and spectral analysis to classify botanical origin and determine adulteration of raw honey

Progress of Research on Detection of Honey Adulteration

Determination of Invert Syrup Adulterated in Acacia Honey by Terahertz Spectroscopy with Different Spectral Features.

Study on Distribution Pattern of Stable Carbon Isotope Ratio of Chinese Honeys by Isotope Ratio Mass Spectrometry

Direct Determination of 4-Methylimidazole and 2-Methylimidazole in Honey by High Performance Liquid Chromatography-Quadrurpole/electrostatic Field Orbitrap High Resolution Mass Spectrometry

Correction to Adulteration Identification of Commercial Honey with the C-4 Sugar Content of Negative Values by an Elemental Analyzer and Liquid Chromatography Coupled to Isotope Ratio Mass Spectroscopy

Determination of Pesticides and Antibiotics in Honey by QuEChERS-HPLC-MS/MS

Comparison of Various Signal Processing Techniques and Spectral Regions for the Direct Determination of Syrup Adulterants in Honey Using Fourier Transform Infrared Spectroscopy and Chemometrics

Untargeted and Targeted Discrimination of Honey Collected by Apis cerana and Apis mellifera Based on Volatiles Using HS-GC-IMS and HS-SPME-GC-MS.

Comparison of Volatile Profiles of Meads and Related Unifloral Honeys: Traceability Markers

Classification of Chinese Honeys According to Their Floral Origins Using Elemental and Stable Isotopic Compositions.

Quantitative determination of acacia honey adulteration by terahertz-frequency dielectric properties as an alternative technique

Confirmatory Analysis of Nitroimidazoles and Hydroxy Metabolites in Honey by Dispersive-Solid Phase Extraction and Ultra-High Performance Liquid Chromatography-Tandem Mass Spectrometry

Identification of the Botanical Origins of Honey Based on Nanoliter Electrospray Ionization Mass Spectrometry.

Determination of Possible Adulteration and Quality Assessment in Commercial Honey

Hydroxy Fatty Acids As Novel Markers for Authenticity Identification of the Honey Entomological Origin Based on the GC-MS Method

Determination of essential and potentially toxic trace elements in honey by inductively coupled plasma-based techniques