Abstract:Bimetallic catalysts are of great interest because they often display properties that differ from either of their parent metals. Previous studies on the Ni/Pt(111) bimetallic system have shown that the location of Ni atoms in the Pt(111) surface has a strong influence on the electronic and chemical properites of the surface [1]. The bimetallic surface consisting of a monolayer of Ni on top of bulk Pt(111), designated Ni-Pt-Pt(111), binds hydrogen and alkenes much more strongly than either parent metal, resulting in decreased hydrogenation activity. In contrast the surface consisting of a monolayer of Ni atoms in the subsurface region designated as Pt-Ni-Pt(111), has been shown to weaken metal-hydrogen bonds in comparison to Ni-Pt-Pt(111) or either parent metal surface. The resulting abundance of weakly bound hydrogen and alkenes on the Pt-Ni-Pt(111) surface increases its activity for novel low temperature hydrogenation pathways [2, 3]. In a previous attempt to extend these single crystal surface science studies to supported catalysts, PtCo bimetallic catalysts were found to be more active to hydrogenation reactions than PtNi bimetallic catalysts [4]. Therefore this study will focus on PtCo catalysts and the effect of different support materials on catalyst structure and activity. Co and Pt monometallic and PtCo bimetallic catalysts were synthesized and supported on γ-Al 2O 3, SiO 2, TiO 2, and activated carbon (AC). Temperature programmed reduction (TPR) studies were performed to characterize the reduction behavior of the catalysts and to identify suitable reduction conditions. CO chemisorption was used to determine the number of active sites on each catalyst. Flow reactor studies of benzene hydrogenation the series of catalysts were used to compare the activity of PtCo on the different supports. Normalizing the hydrogenation activity with the number of active sites yielded the following trend in activity: SiO 2 → Al 2O 3 → TiO 2 ∼ AC. Activation barriers were also calculated and followed a trend consistent with the normalized activity trend, that is: SiO 2 < Al 2O 3 < TiO 2 ∼ AC. Extended X-ray absorption fine structure (EXAFS) spectroscopy was used to characterize the extent of bimetallic formation. EXAFS analysis found that the SiO 2 and Al 2O 3 supported catalysts showed a greater extent of bimetallic formation (larger Pt-Co coordination number) than either the TiO 2 or AC supported catalysts. Both the TiO 2 and AC supported catalysts possessed large Pt-Pt coordination numbers, suggesting the presence of larger particles. Transmission electron microscopy (TEM) was utilized to characterize the particle sizes. Particles on the SiO 2 supported catalyst appeared to be the smallest and most dispersed, while larger particles were observed in both the TiO 2 and AC supported catalysts.

AlCl3-promoted MCM-41-supported platinum catalysts with high activity and sulfur-tolerance for tetralin hydrogenation: Effect of Al/Pt ratio

Al(CH3)3-promoted Pt/MCM-41 catalysts for tetralin hydrogenation in the presence of benzothiophene and promotion mechanism of Al-promoted Pt/MCM-41 catalysts

AlCl3-promoted MCM-41-supported platinum catalysts with high activity and sulfur-tolerance for tetralin hydrogenation: Effect of Pt-Al interaction

Enhancing tetralin hydrogenation activity and sulphur-tolerance of Pt/MCM-41 catalyst with Al(NO3)3, AlCl3 and Al(CH3)3

Supported Nanometric Platinum–nickel Catalysts for Solvent-Free Hydrogenation of Tetralin

Preparation of PtCl_6~(2-) Intercalated Mg/Al-hydrotalcite Catalyst and Its Catalytic Activities for the Hydrosilylation of Olefins

Catalytic Properties of Ptsn/Al2o3/Mcm-41 Catalysts for Propane Dehydrogenation

Support Effects on Methane Two-step Homologation over Pt/MCM-41 Catalysts

Enhancement of Pt Catalytic Activity in the Hydrogenation of Aldehydes

Support effect on the low-temperature hydrogenation of benzene over PtCo bimetallic catalysts

Preparation of Pt/Al 2 O 3 catalyst in CTAB microemulsion and kinetics of m -chloronitrobenzene hydrogenation

Regulating the Pt dispersion by increasing the specific surface area of Al 2 O 3 support for perhydro-dibenzyltoluene catalytic dehydrogenation reaction

Thioresistant PdPt/Al/SBA-15 for Naphthalene Hydrogenation

The Effect of Chromium on Sulfur Resistance of Pd/HY–Al2O3 Catalysts for Aromatic Hydrogenation

Stability and Thermodynamics of the Ptcl2 Type Catalyst for Activating Methane to Methanol: A Computational Study

Support Effect on the Low-Temperature Hydrogenation of Benzene over PtCo Bimetallic and the Corresponding Monometallic Catalysts

The Acid Roles of PtSn@Al2O3 in the Synthesis and Performance of Propane Dehydrogenation

Optimizing Pt/Pd Ratios for Enhanced Low-Temperature Catalytic Oxidation of CO and C3H6 on Al2O3 Support

Effect of Oxidized Tin Interfacial Atoms on Methylcyclohexane Dehydrogenation Catalyzed by γ‐Alumina Supported Platinum Clusters

The Effect of Titania Polymorph on the Strong Metal-Support Interaction of Pd/TiO2 Catalysts and Their Application in the Liquid Phase Selective Hydrogenation of Long Chain Alkadienes

Good Sulfur Tolerance of a Mesoporous Beta Zeolite-Supported Palladium Catalyst in the Deep Hydrogenation of Aromatics