Abstract:In an attempt to overcome silanophilic interactions like observed on popular reversed-phase butyl‑bonded silica stationary phases in protein HPLC, a mixed-mode stationary phase based on wide pore silica (3 µm, 300 Å) was prepared by co-immobilization of octyl and 2-pyridylethyl ligands. The surface modification was performed by a new approach using synthesized functional silatranes of the above ligands and prewetted silica. It allowed to generate a dense polymeric siloxane layer on the silica surface. Butyl-bonded silica and octyl/3-aminopropyl-bonded mixed-mode silica phases were prepared for comparison. The modified silicas were subsequently characterized by elemental analysis regarding ligand densities, by solid-state 29Si and 13C cross polarization/magic angle spinning nuclear magnetic resonance spectroscopy for confirming the surface-bonded structure, and by pH-dependent ζ-potential measurements via electrophoretic light scattering providing net surface charge information at distinct pH values. While the classical butyl‑bonded stationary phase revealed negative ζ-potential over the entire pH range investigated (pH 3.5-9.5) due to residual silanols and the mixed-mode octyl/3-aminopropyl-bonded silica positive ζ-potential over the entire pH range, pH-dependent charge reversal was observed at approximately pH 5.5 for the octyl/pyridyl-bonded stationary phase. Then, a test set of proteins differing in hydrophobicities and isoelectric points was employed to evaluate the retention characteristics of all three synthesized stationary phases over the pH range of 3 to 7.5 by acetonitrile-gradient elution reversed-phase HPLC. Under acidic conditions (pH 3) the mixed-mode phases octyl/pyridyl-silica and octyl/aminopropyl-silica showed reduced retention and improved peak shapes due to repulsive interactions preventing silanophilic interactions, while protein separations by their hydrophobicities were achieved (repulsive charge-assisted protein RPLC). Finally, the prepared novel mixed-mode octyl/pyridyl-bonded stationary phase was evaluated in hydrophobic charge induction chromatography mode for protein separation of the same test set. Instead of an organic modifier gradient, elution was enforced by a pH gradient from almost neutral to acidic pH at constant organic modifier content of 10 %. This chromatographic mode showed orthogonal retention characteristics and reversed elution order compared to above organic gradient RP-HPLC. In addition, significantly less organic solvent was used under these conditions, classifying it as a green protein LC technology.

Polyamidoamine-grafted Silica Nanoparticles As Pseudostationary Phases for Capillary Electrochromatographic Separation of Proteins.

Mesoporous silica nanoparticles incorporated hybrid monolithic stationary phase immobilized with pepsin for enantioseparation by capillary electrochromatography

Synthesis of Zwitterionic Polymer Brushes Hybrid Silica Nanoparticles Via Controlled Polymerization for Highly Efficient Enrichment of Glycopeptides

An adhesive hydrogel functionalized silica sphere for polar analytes separation and analysis

Fabrication of Monodisperse Porous Silica Microspheres with a Tunable Particle Size and Pore Size for Protein Separation.

Synthesis and characterization of macroporous silica modified with optically active poly[N- (oxazolinylphenyl)acrylamide] derivatives for potential application as chiral stationary phases

Aqueous chromatography utilizing pH-/temperature-responsive polymer stationary phases to separate ionic bioactive compounds

Hydrophilic interaction chromatographic evaluation of zwitterionic polymer grafted silica gel via multiple binding sites

Wide-pore fully porous mixed-mode octyl/pyridyl-bonded silica material with pH-dependent surface charge reversal for high-performance hydrophobic charge-induction chromatography of proteins

Tetrasulfonate Calix[4]arene Modified Large Pore Mesoporous Silica Microspheres: Synthesis, Characterization, and Application in Protein Separation.

Electrochromatographic Properties of Synthetic Poly(styrene-Divinylbenzene) Encapsulated Packing Material and Sulphonic Cation-Exchange Phase Based on the Former.

Thermally-modulated on/off-adsorption materials for pharmaceutical protein purification

Preparation and chromatographic evaluation of hydrophilic polymer brushes grafted-silica with post modification of silicon/carbon dots as a green liquid chromatography stationary phase

Cyano-Modified Molecular Cage Silica Gel Stationary Phase: Multi-functional Chromatographic Performance by High-Performance Liquid Chromatography

Incorporation of silica nanoparticles into porous templates to fabricate mesoporous silica microspheres for high performance liquid chromatography applications

Preparation and chromatographic evaluation of a mixed polymer brush–silica stationary phase with temperature-sensitive property

Protein adsorption to the bare silica wall in capillary electrophoresis quantitative study on the chemical composition of the background electrolyte for minimising the phenomenon

The Polystyrene-Divinylbenzene Stationary Phase Modified with Poly (Amine-Epichlorohydrin) for Ion Chromatography

Sorption and separation of platinum and palladium from aqueous solution by aminophosphonic acid functionalized silica

Silica-based strong anion exchange media for protein purification

Dynamically Coating the Capillary with Cationic Polymer for Basic Protein Separation by Capillary Electrophoresis