Abstract:The increasing demand for ethylene glycol (EG) for the manufacture of polyester fibers and resins in the plastic industry and as antifreeze in the automotive industry, together with the urge to replace fossil resources by renewable alternatives, leads today's society for the search of new sustainable processes like EG production from biomass. However, although many studies have been conducted on the catalytic conversion of cellulose to EG, the main issue that remains a challenge is to achieve adequate catalyst stability. To fulfil this gap, herein, a series of Ni–W-based catalysts supported on carbon nanotubes (CNT) were prepared and characterized by several techniques (TG, SEM, EDS, XRD, ICP and N2 adsorption). Cellulose was initially used as model feedstock for a comparative study on its reaction pathways, which effective control is fundamental to maximize EG production. In this work, cellulose was completely converted over Ni–W/CNT catalysts producing an EG yield over 50% after 5 h. The notable performance was attributed to the equilibrium between retro-aldol condensation and hydrogenation reactions achieved through the optimal conjugation of nickel and tungsten active sites. The best catalyst was then evaluated for EG direct production from lignocellulosic residues, such as eucalyptus wood, corncob and cotton wool. Unprecedented EG yields up to 46% were directly attained from the lignocellulosic wastes in just cheap and non-toxic water in the presence of pressurized hydrogen, under mild conditions and using promising environmentally friendly and cost-effective earth-abundant metal catalysts in replacement of noble metals (e.g. Ru). The catalysts presented good stability in hydrothermal conditions during repeated use for at least 6 cycles, demonstrating a promising outlook for future developments. Accordingly, 20%Ni–20%W/CNT is here presented as a potential cost-effective catalyst solution for the mandatory reduction of the dependence on petroleum.

Catalytic conversion of cellulose to ethylene glycol over a low-cost binary catalyst of Raney Ni and tungstic acid.

Selective (ligno) cellulose hydrogenolysis to ethylene glycol and propyl monophenolics over Ni–W@C catalysts

Enhanced Ni/W/Ti Catalyst Stability from Ti–O–W Linkage for Effective Conversion of Cellulose into Ethylene Glycol

Nickel-tungsten co-doped biochar catalyst boosting ethylene glycol production from cellulose hydrogenolysis

Paving the way towards an eco- and budget-friendly one-pot catalytic conversion of cellulose and lignocellulosic residues into ethylene glycol over Ni–W/CNT catalysts

Low-Cost Ni-W Catalysts Supported on Glucose/Carbon Nanotube Hybrid Carbons for Sustainable Ethylene Glycol Synthesis

MOFs-derived hierarchical porous carbon confining the monodisperse Ni and defective WOx for efficient and stable hydrogenolysis of cellulose to ethylene glycol

Unraveling the Active States of WO3-based Catalysts in the Selective Conversion of Cellulose to Glycols

Selectively chemo-catalytic hydrogenolysis of cellulose to EG and EtOH over porous SiO2 supported tungsten catalysts

Bimetal Oxide Catalysts Selectively Catalyze Cellulose to Ethylene Glycol

Ru-WO X -doped biochar for selective ethylene glycol production from cellulose hydrogenolysis: Unravelling the role of WO X in adjusting acid-metal balance

Kinetic Insight into the Effect of the Catalytic Functions on Selective Conversion of Cellulose to Polyols on Carbon-Supported WO 3 and Ru Catalysts

MOF‐derived Ni‐WxC/carbon catalysts: Application to cellulose conversion into glycols

Accurate location of Ni and W active sites in hierarchical zeolite catalyst for the conversion of cellulose to alcohols

Tungsten Trioxide Promoted Selective Conversion of Cellulose into Propylene Glycol and Ethylene Glycol on a Ruthenium Catalyst

Investigation of the effect of zeolite supports and the role of W species for the one-pot catalytic conversion of cellulose to ethylene glycol: Theoretical and Experimental Studies.

Fabrication of immobilized nickel nanoclusters decorated by C N species for cellulose conversion to C2,3 oxygenated compounds: Rational design via typical C- and N-sources

Cellulose Conversion to Polyols on Supported Ru Catalysts in Aqueous Basic Solution

Reaction pathways and selectivity in the chemo-catalytic conversion of cellulose and its derivatives to ethylene glycol: A review

Reaction network and kinetics for the one-pot hydrogenolysis of cellulose to ethylene glycol over NiOx-WOy-Cu/MgAl2O4

One-Step Electrochemical Ethylene-to-Ethylene Glycol Conversion over a Multitasking Molecular Catalyst.