A Rhodamine 6g Derivative As "Turn-On" Fluorescent Probe for Cu2+. Spectroscopy, Single Crystal Structure and Dft Calculations
Tianrong Li,Yang,Panpan Zhou,Zhou Peng,Jingcan Qin,Li Liu,Yuhua Wang
DOI: https://doi.org/10.1016/j.poly.2017.03.014
IF: 2.975
2017-01-01
Polyhedron
Abstract:In order to achieve an effective “turn-on” fluorescence detection of Cu2+, a rhodamine 6G-based sensor [1-phenyl-3-methyl-5-hydroxypyrazole-4-benzoyl(rhodamine 6G) hydrazone, 1] was prepared. Fluorescence and UV–Vis absorption titration, detection limit, single crystal structure, binding mode, and quantum mechanical calculation studies were also discussed in detail. Sensor 1 showed highly selectivity and sensitivity to Cu2+ among common cations (Na+, K+, Mg2+, Ca2+, Mn2+, Co2+, Ni2+, Zn2+, Cd2+, Cr3+, Fe3+ and Cu2+) in acetonitrile. Upon addition of Cu2+, a new absorption band at 523nm, and a strong emission band centering at 557nm appeared in 1 solution. Relevant solution changed from colorless to purple, and an obvious orange fluorescence emission was given. A maximum fluorescence enhancement of 250 times at 557nm could be made by addition of 6 equivalent of Cu2+. The fluorescence detection limit was calculated to be 2.5μM (0.20ppm) for Cu2+, and 1:1 stoichiometry between Cu2+ and 1 was proved. In the single crystal of 1–Cu2+ complex, rhodamine moiety exhibited an open cycle form. We believe 1 can be a good candidate for the fluorescence detection of Cu2+.