Raman-based optical instrument development for rapid and non-destructive detection of pesticide on apple surface

Sagar Dhakal,Yongyu Li,Yankun Peng,Hui Guo
2013-01-01
Abstract:Apple is the world largest produced and consumed fruit item and also one of the major sources of pesticide poisoning to human health. Although different technologies exist for detection of pesticide residue in fruits and vegetables, there is no solid foundation research for non-destructive and rapid detection of pesticide residue on the surface of fruits and vegetables. This research is based on development of laboratory prototype for non-destructive and rapid detection of commercially available organophosphorous (chlorpyrifos) pesticide on apple surface. An optical instrument system based on Raman spectroscopy (1024x256 pixel resolutions) was set up in laboratory. Laser source of 785 nm was used to excite sample. Red apple samples were brought from same stall of local market. The apples were then cleaned with soap water and rinsed with ionic water to ensure the samples free of pesticide and left to dry at laboratory ambient temperature. Commercially available organophosphorous (48% chlorpyrifos) pesticide was mixed with acetone to prepare different concentration of pesticide solution and droplets of pesticide solution were put onto apple surface and left to dry for 3 h. The Raman spectral signal from different points of apple equatorial region was acquired. Three peaks namely at 341, 632 and 677 cm-1 were identified as most prominent peaks representing chlorpyrifos pesticide. Self-developed system software was used to control Raman spectroscopy system and acquire Raman spectral data, process the acquired data and predict the result based on presence/absence of pesticide at the point of detection. Savitzky-Golay five point filter was used in the developed software to smooth the acquired original Raman spectral data and 8th order polynomial fitting was used to remove the fluorescence background from the Raman signal. A simple algorithm was used in the software to compare the peak position of the Raman spectral signal acquired from sample surface with the Raman spectral peak position of chlorpyrifos pesticide to identify whether the sample is contaminated or free of pesticide. Thus developed hardware-software system could detect pesticide concentration on apple surface to minimum value of 5 ppm within less than 4 s. The system developed in this study is non-destructive, rapid and doesn't require sample preparation. Moreover, the system is designed with compatibility for real time application in industrial floor in future. The optical instrument developed in this study can be a milestone for non-destructive, real-time, rapid and accurate detection of pesticide residue on apple surface as well as other fruits.
What problem does this paper attempt to address?