Industrial Analysis and Determination of Calorific Value for Biomass Based on Thermogravimetry.
Wang Ru,Tian Yishui,Zhao Lixin,Yao Zonglu,Meng Haibo,Hou shulin
DOI: https://doi.org/10.3969/j.issn.1002-6819.2014.05.022
2014-01-01
Abstract:The global energy crisis arouses growing interest in the field of renewable energy all over the world. Biomass is a world-recognized environmentally friendly renewable energy because of its lower contents of N and S element and the approximate zero net emissions of CO2. How to make full use of biomass energy has been an important direction of studies in the field of renewable energy. Biomass combustion is one of the most important technologies for large-scale efficient and clean utilization of biomass energy. The existing study on biomass combustion characteristics in China mostly focus on a kind of biomass, and little on different kinds of biomass. Thermal analysis curves (TGA- DTG- DTA) are commonly used in combustion characteristic analysis and dynamic analysis, but not in biomass combustion analysis. Therefore, this study investigated the combustion characteristics of biomass--agricultural residues (wheat straw, cotton straw, and cornstalk), forestry residues (sawdust), and industrial waste residues (sweet sorghum slag) at different heating rates (5, 10, 20, and 30℃/min) in air by thermo gravimetric analysis technology. Results showed that all the biomass combustion included four main phases:water evaporation stage, devolatilization and combustion stage, fixed carbon combustion stage, and burnout stage. The comprehensive combustion characteristic index S was ordered in wheat straw (XMJ)>cotton stalk (MHJ)> sweet sorghum slag (GLZ)> cornstalk(YMJ)> sawdust (MX). The rise of heating rate could improve the combustion performance of biomass samples. Based on these results, a TGA-DTG-DTA method was proposed to determine the values of industrial analysis of samples. The weightlessness rate of A-B, B-C, and C-D was equal to moisture content, volatile content, fixed carbon content, respectively. The weightlessness rate of point D was the ash content of the sample. Thermal analysis curves under 20℃/min heating rate were recommended for industrial analysis. Meanwhile, a differential thermal analysis method was also proposed to determine calorific value of samples, which was the heat difference of peak area between RS (the heat discharged) and OP (the heat absorbed). The other heat-related curves could be obtained from TA-60WS data processing software built in the instrument. Overall, the best combustion performance could be obtained at the heating rate of 20℃/min for agricultural residues, 5℃/min for sawdust and 10℃/min for sorghum slag. The differential thermal analysis and thermal analysis curve expanded the application of thermogravimetric analysis technology in studies on biomass combustion characteristic. However, their effectiveness and applicability required further verification of more experiments and data. It hoped that this study would provide valuable information for maturing biomass combustion technology in China.