Abstract:Combustion system development in power generation is discussed ranging from the pre-environmental era in which the objectives were complete combustion with a minimum of excess air and the capability of scale up to increased boiler unit performances, through the environmental era (1970–), in which reduction of combustion generated pollution was gaining increasing importance, to the present and near future in which a combination of clean combustion and high thermodynamic efficiency is considered to be necessary to satisfy demands for CO2 emissions mitigation.From the 1970s on, attention has increasingly turned towards emission control technologies for the reduction of oxides of nitrogen and sulfur, the so-called acid rain precursors. By a better understanding of the NOx formation and destruction mechanisms in flames, it has become possible to reduce significantly their emissions via combustion process modifications, e.g. by maintaining sequentially fuel-rich and fuel-lean combustion zones in a burner flame or in the combustion chamber, or by injecting a hydrocarbon rich fuel into the NOx bearing combustion products of a primary fuel such as coal.Sulfur capture in the combustion process proved to be more difficult because calcium sulfate, the reaction product of SO2 and additive lime, is unstable at the high temperature of pulverized coal combustion. It is possible to retain sulfur by the application of fluidized combustion in which coal burns at much reduced combustion temperatures. Fluidized bed combustion is, however, primarily intended for the utilization of low grade, low volatile coals in smaller capacity units, which leaves the task of sulfur capture for the majority of coal fired boilers to flue gas desulfurization.During the last decade, several new factors emerged which influenced the development of combustion for power generation. CO2 emission control is gaining increasing acceptance as a result of the international greenhouse gas debate. This is adding the task of raising the thermodynamic efficiency of the power generating cycle to the existing demands for reduced pollutant emission. Reassessments of the long-term availability of natural gas, and the development of low NOx and highly efficient gas turbine–steam combined cycles made this mode of power generation greatly attractive also for base load operation.However, the real prize and challenge of power generation R&D remains to be the development of highly efficient and clean coal-fired systems. The most promising of these include pulverized coal combustion in a supercritical steam boiler, pressurized fluid bed combustion without or with topping combustion, air heater gas turbine-steam combined cycle, and integrated gasification combined cycle. In the longer term, catalytic combustion in gas turbines and coal gasification-fuel cell systems hold out promise for even lower emissions and higher thermodynamic cycle efficiency. The present state of these advanced power-generating cycles together with their potential for application in the near future is discussed, and the key role of combustion science and technology as a guide in their continuing development highlighted.

Clean Coal Technology Combustion Products. Properties, Agricultural and Environmental Applications, and Risk Management.

Clean Coal Technology Combustion Products

A comprehensive review on the applications of coal fly ash

Characterisation of coal and its combustion ash: recognition of environmental impact and remediation

Advanced Exergoenvironmental Evaluation for a Coal-Fired Power Plant of Near-Zero Air Pollutant Emission

Disposal of coal combustion residues in terrestrial systems: contamination and risk management

Clean Coal Technologies in China: Current Status and Future Perspectives

Mineralogy Of Clean Coal Combustion By-Products

A Typical 300 MW Ultralow Emission Coal-Fired Power Plant: Source, Distribution, Emission, and Control of Polycyclic Aromatic Hydrocarbons

Combustion technology developments in power generation in response to environmental challenges

Progress and Prospects on Clean Coal Technology for Power Generation

Emission and Distribution Behavior of Toxic Elements during the Cocombustion of Coal with Biomass

Physico-chemical characterization of coal combustion by-products derived from thermoelectric power plants

Emission of Organic Components and Distribution Characteristics of PAHs in Condensable Particulate Matter from Coal-Fired Power and Industrial Plants

Coal combustion and its pollution control in China

Current Status of Application to Clean Coal Technology

Distribution and Emission Characteristics of Filterable and Condensable Particulate Matter in the Flue Gas Emitted from an Ultra-Low Emission Coal-Fired Power Plant

Investigation of Air Extraction and Carbon Capture in an Integrated Gasification Combined Cycle (IGCC) System

Towards sustainable coal industry: Turning coal bottom ash into wealth

Utilization and Control of Coal Chemical and Power Station Wastes

The present and future of clean coal technology