Influence of Mg2+, Ni2+, and Cu2+ on Dna Assembly on Hopg Surfaces: Atomic Force Microscopy Study

Lin Zhao,Zhiguo Liu,Yuangang Zu,Zhen Zhou,Tongze Sun

DOI: https://doi.org/10.1002/sca.20277

2011-01-01

Scanning

Abstract:Adsorption of circular DNA onto bare highly oriented pyrolytic graphite (HOPG) surfaces by the addition of Mg2+, Ni2+, and Cu2+ has been investigated by atomic force microscopy (AFM). AFM results revealed that the topography and height of DNA on HOPG surface by the addition of different metal ions are quite different. After the addition of Mg2+ for incubation, DNA molecules tend to form many loops on HOPG surfaces, which are derived from the crossover of intramolecular and intermolecular chains. After the addition of Ni2+, DNA molecules can form network on HOPG surfaces, and the density of DNA network was significantly increased with increasing DNA concentration. Consequently, dense DNA network can be obtained by using relatively low concentration of DNA and Ni2+. As for the addition of Cu2+, angular DNA loops composed of flat chains were observed. The observed flat DNA chains with an average height of 0.52?nm can be ascribed to Cu2+ insert into the site between bases and phosphate group of DNA inducing denaturation of DNA molecules. This study is very helpful for understanding the interactions of metal ions and DNA molecules, and for constructing various DNA structures on the carbonaceous surfaces. SCANNING 34: 6875, 2012. (c) 2011 Wiley Periodicals, Inc.