Please Scroll down for Article International Journal of Smart and Nano Materials Extension Limit, Polarization Saturation, and Snap-through Instability of Dielectric Elastomers Extension Limit, Polarization Saturation, and Snap-through Instability of Dielectric Elastomers
Bo Li,Liwu Liu,Z. Suo
Abstract:This article may be used for research, teaching and private study purposes. Any substantial or systematic reproduction, redistribution , reselling , loan or sub-licensing, systematic supply or distribution in any form to anyone is expressly forbidden. The publisher does not give any warranty express or implied or make any representation that the contents will be complete or accurate or up to date. The accuracy of any instructions, formulae and drug doses should be independently verified with primary sources. The publisher shall not be liable for any loss, actions, claims, proceedings, demand or costs or damages whatsoever or howsoever caused arising directly or indirectly in connection with or arising out of the use of this material. A dielectric elastomer is capable of large voltage-induced deformation, particularly when the voltage is applied on the verge of snap-through instability. A model is described which shows that the snap-through instability is markedly affected by both the extension limit of polymer chains and the polarization saturation of dipoles. The model may guide the search for high-performance dielectric elastomer transducers. 1. Introduction When subjected to a voltage through its thickness, a membrane of a dielectric elastomer reduces in thickness and enlarges in area (Figure 1). This electromechanical coupling is being studied intensely for diverse applications, including soft robots, adaptive optics, Braille displays, and electric generators [1–10]. Voltage-induced strains over 100% have been achieved in several ways, by pre-stretching an elastomer [11], by using an elastomer of interpenetrating networks [12], by swelling an elastomer with a solvent [13], and by spraying charge on an electrode-free elastomer [14]. When the voltage ramps up, the membrane thins down, so that the same voltage will induce an even higher electric field. This positive feedback results in the pull-in instability [15]. The pull-in instability is commonly considered a mode of failure: the voltage causes the elastomer to reduce the thickness drastically, possibly leading to electrical breakdown [16]. In recent years, the pull-in instability has been analyzed within the context of dielectric elastomer transducers [17–24]. It was recognized recently, however, that an elastomer may survive the pull-in instability without electrical breakdown, and be stabilized in a state of a much smaller thickness, resulting in the snap-through instability [25]. This behavior is understood as follows. When the elastomer is subject to mechanical forces (Figure 2a), on approaching the extension limit, λ lim , the elastomer stiffens steeply. When the deformation is caused by …