Adhesion Behavior of Rabbit Adipose-Derived Stromal Cells on Chitosan-Modified Polypropylene Mesh

CHENG Hui,WU Qing-kai,SUN Jun-fen,ZHANG Rong,TENG Yin-cheng,LUO Lai-min,DOU Hong-jing
DOI: https://doi.org/10.3969/j.issn.1674-8115.2012.04.006
2012-01-01
Abstract:Objective To study the technical parameters of chitosan-modified polypropylene mesh,and observe the adhesion behavior of rabbit adipose-derived stromal cells(ADSCs) on the modified mesh.Methods Chitosan of 1 g,1.25 g and 1.5 g were respectively dissolved into the mixture of 2% acetic acid solution,5% glutaraldehyde solution and 50% n-heptane solution,and 2.0%,2.5%,3.0% chitosan mould solutions were obtained.Polypropylene meshes were modified by different concentrations of chitosan mould solutions,and then the chitosan-modified polypropylene meshes were obtained.Rabbit ADSCs were cultured with chitosan-modified polypropylene meshes for 24 h,and the adhesion behavior of cells on materials was observed.Results Chitosan-modified polypropylene meshes were harder than non-modified polypropylene meshes,and the plasticity of polypropylene meshes decreased with the concentration increase of chitosan solutions.Polypropylene mesh modified by 3.0% chitosan solution had the phenomenon of uneven coating.After co-culture for 24 h,rabbit ADSCs grew well on modified polypropylene meshes,while there was no rabbit ADSCs growing on the non-modified polypropylene meshes.Conclusion The ideal concentration of the chitosan solution for modified polypropylene mesh is 2.5%,and chitosan-modified polypropylene mesh is suitable for rabbit ADSCs adhesion.
What problem does this paper attempt to address?