Abstract:In the present paper, p-CdS/n-Si heterojunction solar cells are prepared for the first time by the spray pyrolysis technique. Using such low-cost method, cells with 6.4% AMI conversion efficiency and 0.32 fill factor have been made. The forward current of the prepared cells is dominated by the tunneling-recombination mechanism. Spectral response measurements revealed that these cells exhibit a wide spectral response (400-II50 nm) with two distinct peaks, the first at A-=550nm, while the second at A-=800nm. Photo-induced open-circuit voltage decay technique illustrated that the minority carriers lifetime of these cells is around 20!JS. Introduction There has been considerable interest in recent years directed towards the development of heterojunction solar cells [I-3]. Such interest is based on the fact that heterojunction devices have a number of advantages over diffused p-n junction solar cells include [4]: (i) a lower junctionformation temperature, (ii) higher spectral response at short wavelengths, and (iii) many of deposited layers have the right indices of refraction to act as antireflection coating. CdS/Si and Indoped CdS/Si heterojunction solar cells have been reported to have power conversion efficiencies of 4% and greater [5-8]. The CdS films in these devices are deposited by different methods. Most of these films are deposited by either evaporation or sputtering in a vacuum and post-deposition heat treatments are necessary. However, no attempt is reported for depositing CdS onto Si by chemical spray pyrolysis technique yet. In this letter, we report the preliminary results of the first fabrication of p-CdS/n-Si heterojunction solar cells made by chemical spray pyrolysis technique. Preliminary aspects of this work have been reported earlier [9,IO]. Experimental Procedures Single-crystal silicon wafers of n-type with (lli) orientation are used as substrates, they have a resistivity in the range of I-5 D-cm, and one face ofthe wafer is polished to the mirror-like surface. Prior to deposition of CdS, the wafers were chemically etched in dilute hydrofluoric acid to remove native oxides. Then back contact metallization was accomplished by vacuum depositing 200 nm layer of Al. Subsequently, after removal from the vacuum chamber, the wafers were scribed into individual pieces of 0.5cm sizes, then they were sent to spraying apparatus. The deposition of CdS films was carried out by spraying an aqueous solution of CdCh and thiourea onto a heated silicon substrate maintained at 450° C. A typical spray mixture, which gave us good results, consists of an 0.2 M solution of cadmium salt and 0.2 M solution of thiourea. This solution is sprayed in a deposition rate of about 2nm/s. After the deposition of CdS, frontal metal electrode is a 200nm layer of Al through a metal mask. The sensitive area was about 0.2cm. The optical transmittance of the CdS thin films prepared on glass substrates was measured using (UVNIS-PV-8800) spectrophotometer covering the range 400-900 nm. Spectral responsivity measurements of CdS/Si heterojunction solar cells were made by using a monochromator (MODEL 746) in the range 400IIOO nm (the spectrum of interest in the operation of solar cells under terrestrial applications). The results were calibrated by measuring the power of each spectral line using a standard power meter. (J-V) measurements were done under dark and illuminated conditions. The illumination was achieved under simulated AMI condition (93 mW/cm) by a halogen lamp type "PHILIPS"; I20 W, which connected to a Variac and calibrated by a silicon powermeter. The type of conductivity of CdS film was determined by using Hall measurement. The minority carrier lifetime of the cells was

SnS homojunction nanowire-based solar cells

Hybrid heterojunction and photoelectrochemistry solar cell based on silicon nanowires and double-walled carbon nanotubes.

Bandgap-Graded CdSxSe1-x Nanowires for High-Performance Solar Cells

SnS Homojunction Solar Cell with n‐Type Single Crystal and p‐Type Thin Film

Vertically aligned ZnCdS nanowire arrays/P3HT heterojunctions for solar cell applications

Heterojunction Photovoltaic Devices Utilizing Single Wall Carbon Nanotube Thin Films and Silicon Substrates

CuInSe2 nanowires from facile chemical transformation of In2Se3 and their integration in single-nanowire devices.

Facile Synthesis Of Monodisperse, Size-Tunable Sns Nanoparticles Potentially For Solar Cell Energy Conversion

Fabrication of Slantingly-Aligned Silicon Nanowire Arrays for Solar Cell Applications

Enhanced Solar Energy Conversion in Au-doped, Single-Wall Carbon Nanotube-Si Heterojunction Cells

Self-Assembled Amphiphilic Block Copolymers/Cdte Nanocrystals for Efficient Aqueous-Processed Hybrid Solar Cells

Light Harvesting and Enhanced Performance of Si Quantum Dot/Si Nanowire Heterojunction Solar Cells

FABRICATION OF SILICON NANOWIRE (SiNW) ARRAYS AND APPLICATION IN SOLAR CELL

Sn‐catalyzed silicon nanowire solar cells with 4.9% efficiency grown on glass

SnO 2 hollow nanospheres enclosed by single crystalline nanoparticles for highly efficient dye-sensitized solar cells

Silicon Nanowires Incorporated Efficient and Flexible PEDOT:PSS/Silicon Hybrid Solar Cells

p-CdS / nSi Anisotype Heterojunction Solar Cells With Efficiency of 6 . 4 ° / o

Core-Shell Heterojunction of Silicon Nanowire Arrays and Carbon Quantum Dots for Photovoltaic Devices and Self-Driven Photodetectors

Optical absorption enhancement in amorphous silicon nanowire and nanocone arrays.

Amorphous silicon core-shell nanowire Schottky solar cells

CuO Nanowires-Based Radial Hetero-Junction Thin Film Silicon Solar Cells with a High Open-Circuit Voltage