Abstract:The accurate diffusivity and kinetic database of fcc quinary Cu–Co–Mn–Ni–Si system is essential for designing high-performance Cu alloys, which is still not investigated yet. In the present work, on the basis of the critically reviewed experimental diffusivities available in the literature, the atomic mobilities of fcc Mn–Ni and Cu–Mn–Ni alloys were re-assessed through CALTPP (CALculation of ThermoPhysical Properties) program, aiming to establish a self-consistent kinetic database for fcc Cu–Co–Mn–Ni–Si system. Comparing the model-calculated diffusion coefficients, composition profiles and diffusion paths with the measured ones for fcc Mn–Ni and fcc Cu–Mn–Ni alloys, it is found that the experimental data are reasonably reproduced by the re-assessed atomic mobilities, indicating their good reliability. Therefore, integrating the presently obtained atomic mobilities for the fcc Mn–Ni and fcc Cu–Mn–Ni systems with those for other sub-systems, a complete kinetic database for fcc Cu–Co–Mn–Ni–Si system was established for the first time. The reliability of the constructed kinetic database was confirmed by the reasonable agreements between the model-predicted composition profiles of sub-quaternary and quinary diffusion couples and the measured ones. Furthermore, this obtained kinetic database was applied to simulate the microstructure evolution of second-phase precipitates in Cu–Mn–Ni, Cu–Ni–Si and Cu–Ni–Co–Si alloys during the aging process, and the simulated results demonstrate good agreements with the experimental ones. The present work indicates the reliability and significance of the presently obtained kinetic database of fcc quinary Cu–Co–Mn–Ni–Si system for predicting the microstructure evolution during the heat treatment process, which can greatly contribute to the design of Cu alloys with high performance.

Diffusivities and Atomic Mobilities in Cu-rich Fcc Al–Cu–Mn Alloys

Diffusivity and atomic mobility in fcc Cu–Mn–Si alloys: measurements and modeling by CALTPP program

Assessment of Mobilities of the B2 Phase in the Nickel-Chromium-Aluminum System

Diffusion mobilities for the B2-b.c.c. phase in the Ni–Al binary system

Interdiffusion and atomic mobility in FCC Ag–Cu–Ni alloys

A Finite Difference Method for Determining Interdiffusivity of Aluminide Coating Formed on Superalloy

Diffusion kinetics for fcc quinary Cu–Co–Mn–Ni–Si system and its application to precipitation simulations

Interdiffusion In Liquid Al-Cu And Ni-Cu Alloys

Concentration-dependent atomic mobilities in FCC CoCrFeMnNi high-entropy alloys

Development of atomic mobility with quantified uncertainties directly from concentration profiles: a demo in fcc Cu–Ni–Sn system

Thermodynamic Assessment of the Fe–Mn–Ni System and Diffusion Mobility of Its Face-Centered Cubic Phase

Interdiffusion and atomic mobility of the Mg-Ag-Zn system

Interdiffusion in the FCC-structured Al-Co-Cr-Fe-Ni High Entropy Alloys: Experimental Studies and Numerical Simulations

The diffusion behaviors at the Cu-Al solid-liquid interface: A molecular dynamics study

Composition- and Temperature-Dependent Liquid Structures in Al–Cu Alloys: Anab Initiomolecular Dynamics and X-Ray Diffraction Study

Study on diffusion characteristics of Al-Cu systems and mechanical properties of intermetallics

Diffusion Coefficients of the Ni-Co-Fe Alloys Studied by Molecular Dynamics Simulation and CALPHAD Assessment

Diffusion in Ni-Based Single Crystal Superalloys with Density Functional Theory and Kinetic Monte Carlo Method

Molecular Dynamics Study of Stability of Solid Solutions and Amorphous Phase in the Cu-Al System

Diffusion behavior in Nickel-Aluminium and Aluminium-Uranium diluted alloys

Atomic diffusion behavior and diffusion mechanism in Fe–Cu bimetal casting process studied by molecular dynamics simulation and experiment