Toughening of Poly(L-Lactic Acid) by Annealing: the Effect of Crystal Morphologies and Modifications

Guanghui Yang,Juanjuan Su,Run Su,Qin Zhang,Qiang Fu,Bing Na

DOI: https://doi.org/10.1080/00222348.2011.565263

2011-01-01

Journal of Macromolecular Science Part B

Abstract:Poly(L-lactic acid) (PLA) samples prepared by hot pressing were treated by two different processes: process a—quenching of the molten specimens in water, then annealing at high temperatures; process b—direct crystallization at high temperatures from the molten specimens. The crystal modification and morphology of PLA were investigated by differential scanning calorimetry, dynamic mechanical analysis, polarized light microscopy, and wide-angle X-ray diffraction. In the case of process a, the α′ (disordered α) crystal modification was formed at relatively low annealing temperature (T a < 100°C), while the ordered α phase was formed in the case of process a at high T a (> 100°C) and process b. Furthermore, in process a, the nucleation density of spherulites was higher and the radius of the spherulites was much smaller compared with that of the spherulites formed by process b. The effects of crystal modification and morphology on the impact behaviors of PLA were investigated by notched Izod impact testing. The macroscopic fracture toughness was discussed in terms of the microscopic structures. Finally, we suggest an alternative approach for the preparation of high-performance PLA.