Abstract:Using solar energy to split CO2 can realize the conversion and storage of solar energy at the same time, and alleviate the carbon emissions caused by the transitional use of fossil energy. Solar energy based photo-thermochemical reaction is a promising method for the CO2 splitting. To further study the photo-thermochemical reaction mechanism and explore the non-titanium-based catalytic materials, the ZnO/Zn2GeO4 composite material (Z/ZGO) was prepared by solution precipitation method and used for photo-thermochemical CO2 splitting. Composite semiconductor combined the advantages of the two components which made CO production reach 5.55 times that of pure ZnO. Scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy dispersive spectrometer (EDS), X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS) were used to illustrate the crystal structure and chemical composition of the samples. The XRD pattern found that the samples crystallized well, and no obvious crystal form changes occurred after the reaction. Using SEM to observe the samples before and after the reaction, the particle size did not increase significantly and no obvious sintering phenomenon was found, which indicated that the material has good reaction stability. Photoluminescence (PL), UV-visible diffuse reflectance spectra (UV-visible DRS) and Mott-Schottky plots were used to evaluate the material's light absorption characteristics and energy band position. The band gap of ZnO and Zn2GeO4 samples were 3.27 eV and 4.56 eV, respectively, and the heterojunction was formed in the Z/ZGO sample. The presence of ZnO extended the spectral response range of Zn2GeO4, and due to the migration of photogenerated electron-hole pairs (EHPs) to ZnO, the recombination of EHPs w as reduced. XPS analyses were also used to investigate change of oxygen vacancies during the reaction. The O is XPS spectra of the samples in the three cases (Case A: before light irradiation, Case B: after light irradiation and Case C: after reaction) were analyzed and found that the signal of the oxygen near the vacancies increased after light irradiation and decreased after reaction, which may indicate that oxygen vacancies were formed after light irradiation then consumed by CO2 in the reaction. The Zn2GeO4 sample showed the largest increase in oxygen vacancies signal after light irradiation, indicating that Zn2GeO4 had a strong ability to form oxygen vacancies. Zn2GeO4 improves the capacity of oxygen vacancies formation in the sample. and further improved the yield of photo-thermochemical CO2 splitting reaction. As a result, Z/ZGO combined the advantages of ZnO in light response and Zn2GeO4 in oxygen vacancies formation and improved the CO2 splitting yield. This research has a positive effect on expanding the photo-thermochemical material system and further deepening the photo-thermochemical reaction mechanism.

Zn2GeO4crystal Splitting Toward Sheaf-Like, Hyperbranched Nanostructures and Photocatalytic Reduction of CO2into CH4under Visible Light after Nitridation

An Anion-Controlled Crystal Growth Route to Zn2GeO4 Nanorods for Efficient Photocatalytic Conversion of CO2 into CH4.

Single-Crystalline, Ultrathin ZnGa2O4 Nanosheet Scaffolds to Promote Photocatalytic Activity in CO2 Reduction into Methane

ChemInform Abstract: Facile Temperature‐Controlled Synthesis of Hexagonal Zn2GeO4 Nanorods with Different Aspect Ratios Toward Improved Photocatalytic Activity for Overall Water Splitting and Photoreduction of CO2.

Photo-thermochemical CO2 Splitting Based on Zinc-germanium Binary Oxide

ChemInform Abstract: Synthesis of Highly Crystalline In2Ge2O7(En) Hybrid Sub‐Nanowires with Ultraviolet Photoluminescence Emissions and Their Selective Photocatalytic Reduction of CO2 into Renewable Fuel.

Engineering Built‐In Electric Field Microenvironment of CQDs/g‐C3N4 Heterojunction for Efficient Photocatalytic CO2 Reduction

ChemInform Abstract: High‐Yield Synthesis of Ultralong and Ultrathin Zn2GeO4 Nanoribbons Toward Improved Photocatalytic Reduction of CO2 into Renewable Hydrocarbon Fuel.

Atomically Thin Zn2GeO4 Nanoribbons: Facile Synthesis and Selective Photocatalytic CO2 Reduction Toward CO

Atomically Thin Zn 2 GeO 4 Nanoribbons: Facile Synthesis and Selective Photocatalytic CO 2 Reduction toward CO

Surface CN Bonds Mediate Photocatalytic CO2 Reduction into Efficient CH4 Production in TiO2-decorated G-C3n4 Nanosheets

Ultrathin, Single-Crystal WO(3) Nanosheets by Two-Dimensional Oriented Attachment Toward Enhanced Photocatalystic Reduction of CO(2) into Hydrocarbon Fuels under Visible Light.

ZnO/g-GeC van der Waals heterostructure: novel photocatalyst for small molecule splitting

Enabling Interfacial Lattice Matching by Selective Epitaxial Growth of CuS Crystals on Bi2WO6 Nanosheets for Efficient CO2 Photoreduction into Solar Fuels

Structural reconstruction of carbon nitride with tailored electronic structure: A bifunctional photocatalyst for cooperative artificial photosynthesis and selective phenylcarbinol oxidation

Enwrapping G-C3n4 on In2O3 Hollow Hexagonal Tubular for Photocatalytic CO2 Conversion: Construction, Characterization, and Z-scheme Mechanism Insight.

Crystal Engineering of MOF-Derived Bimetallic Oxide Solid Solution Anchored with Au Nanoparticles for Photocatalytic CO2 Reduction to Syngas and C2 Hydrocarbons

The Synthesis of One Ag@ZnO Micro-nano Composite Structure with High Specific Surface Area and Its Application in Photocatalytic Reduction of Carbon Dioxide

Constructing crystalline-amorphous hydrated niobium pentoxide homojunction for superior photocatalytic CO2 reduction into CH4 with high selectivity

Zn-doped Tri-S-triazine Crystalline Carbon Nitrides for Efficient Hydrogen Evolution Photocatalysis

Zinc-Doped G-C3n4/Bivo4 As A Z-Scheme Photocatalyst System For Water Splitting Under Visible Light