Abstract:Abstract Additive Manufacturing (AM) of ceramics is a constantly emerging field of interest both in research and in industry. Binder jetting-based AM of ceramics in particular offers the opportunity to produce large ceramic parts with a high wall thickness at a high throughput. One limitation is that it requires flowable powders, which are generally coarse and thus exhibit only limited sintering activity. The resulting low sintered densities impede the commercial binder jetting-based production of dense oxide ceramics. We present an approach to efficiently increase the green density of binder jetted alumina parts by optimized slurry infiltration, which also leads to a significant increase in the sintered density. In a first step, alumina parts were fabricated via binder jetting, using a 20-μm-sized alumina powder, yielding relative green densities of about 47–49%. Initial sintering studies with powder compacts showed that sintering even above 1900 °C is not sufficient to achieve acceptable densification. Therefore, green samples were infiltrated with a highly filled ceramic slurry to fill the remaining pores (about 2–5 μm in size) with smaller particles and thus increase the packing density. Particle volume content (40–50 vol%), particle size (100–180 nm) and the infiltration procedure were adapted for tests on cuboid samples to achieve a high penetration of the green bodies and a high degree of pore filling. In this way, the relative green density could be increased starting from about 47% after binder jetting, to 73.4% after infiltration and drying. After sintering at 1675 °C densities above 90% could be achieved, yielding three-point bending strengths up to 145 MPa. As a conclusion, this approach can be regarded as a promising route for overcoming the drawbacks of the binder jetting process on the way to denser, mechanically more stable sintered alumina parts.

Effect of binder on the structure and mechanical properties of lightweight bubble alumina ceramic

Effect of Composite Binder on the Property of Lightweight Bubble Alumina Ceramics

Cost-effective Fabrication of Bio-Inspired Nacre-Like Composite Materials with High Strength and Toughness

Study on fracture mechanism of alumina bubble ceramic

A novel composite binder design for direct ink writing alumina-based ceramics with enhanced strength at low sintering temperature

PREPARATION OF LIGHTWEIGHT ALUMINA CERAMIC AND IN-SITU SYNTHESIS OF NANOMETER ALUMINA POWDERS AS SINTERING AGENT

Effect and mechanism of nano-Ca 10 (PO 4 ) 6 (OH) 2 additive on compressive strength of calcium aluminate cement at high temperature

Effect of sodium silicate solution combined yttrium oxide stabilized zirconia nanopowders on the properties of alumina ceramics fabricated by binder jetting additive manufacturing

Modification of alumina bubbles with ammonium aluminum sulphate

Effect of sintering aid combined vacuum infiltration on the properties of Al 2 O 3 -based ceramics via binder jetting

Lightweight porous Al2O3‐based ceramics with highly controllable performance via binder jetting

Improved green and sintered density of alumina parts fabricated by binder jetting and subsequent slurry infiltration

Study on the Effect of Binders on the Properties of Mullite Porous Ceramics for Flue Gas Filtration

Characterization of ceramic components fabricated using binder jetting additive manufacturing technology

Effects of Solvent Debinding on the Microstructure and Properties of 3D-Printed Alumina Ceramics

Effects of AlN inorganic binder on the properties of porous Si3N4 ceramics prepared by selective laser sintering

Influence of several binders on the mechanical properties of alumina parts manufactured by 3D inkjet printing

Gelcasting of alumina ceramics in the mixed acrylamide and polyacrylamide systems

Effects of the Binder Compositions on the Homogeneity of Ceramic Injection Molded Compacts

Influence of debinding holding time on mechanical properties of 3D-printed alumina ceramic cores

EFFECT OF WATER-SOLUBLE POLYACRYLAMIDE ON GELCASTING OF ALUMINA