Abstract:Heavy metals accumulated in slurry of dual alkali flue gas desulfurization (FGD) present a significant catalysis to SO3(2-) oxidation, resulting in a waste of effective components for desulfurization. Na2S was adopted to precipitate heavy metal ions in FGD slurry, and the oxidation rate of SO3(2-) was obtained under different concentrations of heavy metal ions, to reveal the inhibition effect of Na2S on SO3(2-) oxidation catalyzed by heavy metal ions. Mn2+ showed a remarkable catalysis to SO3(-2) oxidation, as the initial oxidation rate of SO3(2-) was tripled to 0.65 mmol/(L x min) by adding 1.0 mmol/L Mn2+ into the slurry. SO3(2-) was catalytically oxidized rapidly with the reaction order 0.169 of Mn2+ within first 60 minutes, so it is of great importance to control the concentration of Mn2+ to inhibit SO3(2-) oxidation. At initial pH value of 6.50-8.50, Na2S removed heavy metal ions effectively from FGD slurry. Higher pH value favored the removal of heavy metal ions. The removal efficiencies of Mn2+, Zn2+, Ni2+ and Cd2+ were 91.0%, 88.1%, 85.5%, and above 99.9% respectively under the conditions of initial pH value 8.50 and Na2S dosage 240.0 mg/L. Mn2+ could be used as an indicator for the concentration of the heavy metal ions in the slurry. As the Mn2+ concentration decreased from 1.0 mmol/L to 5.0 x 10(-3) mmol/L by adding Na2S, the initial oxidation rate of SO3(2-) decreased by 64.6% to 0.23 mmol/(L x min). The desulfurization efficiencies increase 3.8%-5.1% by adding Na2S in a pilot scale setup. It comes to conclusion that heavy metal ions precipitation by adding Na2S with an indicator of Mn2+ to inhibit catalytic oxidation of SO3(2-) is feasible to reduce the consumption of desulfurizer in FGD slurry.

Effects of Mg2+ on the Bivalent Mercury Reduction Behaviors in Simulated Wet Fgd Absorbents

Review of Elemental Mercury (hg0) Removal by CuO-based Materials

Experimental Study on the Absorption Behaviors of Gas Phase Bivalent Mercury in Ca-based Wet Flue Gas Desulfurization Slurry System

Influence of Flue Gas Components on the Mercury Adsorption/oxidation by Mechanochemical S2Cl2-modified Sawdust Coke

Effects of Coal-Fired Flue Gas Components on Mercury Removal by the Mechanochemical S-Modified Petroleum Coke

Mercury Re-emission Behaviors in Magnesium-Based Wet Flue Gas Desulfurization Process: the Effects of Oxidation Inhibitors

Mercury Removal from Coal Combustion Flue Gas by Mechanochemically Sulfur Modified Straw Coke and Its Mercury Stability

Study of Mercury Re-Emission in A Simulated Wfgd Solution Containing Thiocyanate and Sulfide Ions

Research on Vapor Mercury Adsorption by Ca-Based Sorbents

Effect of Additives on Hg2+ Reduction and Precipitation Inhibited by Sodium Dithiocarbamate in Simulated Flue Gas Desulfurization Solutions.

Hg2+ Reduction and Re-Emission from Simulated Wet Flue Gas Desulfurization Liquors

Laboratory Study on Mercury Release of the Gypsum from the Mercury Coremoval Wet Flue Gas Desulfurization System with Additives

Stabilization of Mercury in Flue Gas Desulfurization Gypsum from Coal-Fired Electric Power Plants with Additives

[Inhibition of Sulfite Oxidation Catalyzed by Heavy Metals in Dual Alkali Flue Gas Desulfurization Slurry].

A review on enhancing sulfur-resistant capacity and magnetism of adsorbent for mercury removal from coal fired flue gas

Mercury Re-Emission in Flue Gas Multipollutants Simultaneous Absorption System.

Process Migration and Transformation of Mercury in Simulated Wet Flue Gas Desulfurization Slurry System

Enhanced Hg2+ Removal and Hg0 Re-Emission Control from Wet Fuel Gas Desulfurization Liquors with Additives

A mechanism study of chloride and sulfate effects on Hg2+ reduction in sulfite solution

Primary Research of Hg2+ Reduction and Stabilization in Wet Flue Gas Desulfurization Liquors

Modeling Of Elemental Mercury Control By Sorbents From Simulated Flue Gases