Abstract:Hierarchical ZSM-5 catalysts were prepared by desilication using NaOH, Na2CO3 and TPAOH with different concentrations under the same treatment conditions. Their structures and acidities were characterized by X-ray diffraction (XRD), scanning electron microscope (SEM), N-2 adsorption and desorption (N-2-BET) and ammonia temperature-programmed desorption (NH3-TPD). The catalytic fast pyrolysis (CFP) of cellulose to produce aromatics over the hierarchical ZSM-5 catalysts prepared using different alkali treatments was investigated. The alkali treatment by Na2CO3 (0.4 similar to 0.8 M) was much milder than treatment by NaOH, which allowed the desilication process to be highly controllable, resulting in an increase of both the amount and strength of the strong acid sites, and the formation of hierarchical structures combining micro- and mesoporosity. The organic hydroxide TPAOH did not change the pore structure of ZSM-5, but it greatly increased the relative crystallinity. The CFP of cellulose with HZSM-5 produced 35.5% liquid aromatic hydrocarbons and 32.7% coke. The yield of aromatics increased after Na2CO3 treatment but decreased after NaOH treatment. In addition, the yield of coke showed the opposite trend. The highest aromatic yield (38.2%) and lowest coke yield were obtained in the CFP of cellulose with the desilicated zeolite treated with 0.6 M Na2CO3. The increased acidity in hierarchical ZSM-5 treated with Na2CO3 increased the selectivity of highly valuable aromatics, such as benzene, toluene, and xylene, and decreased the selectivity of large aromatics. TPAOH-treated HZSM-5 showed a slightly increased yield of aromatics due to the repair effect of TPAOH, but this treatment did not form a mesoporous structure.

Catalytic Fast Pyrolysis of Cellulose Mixed with Sulfated Titania to Produce Levoglucosenone: Analytical Py-GC/MS Study

Catalytic Fast Pyrolysis of Cellulose for the Selective Production of Levoglucosenone Using Phosphorus Molybdenum Tin Mixed Metal Oxides

Catalytic Fast Pyrolysis of Cellulose to Prepare Levoglucosenone Using Sulfated Zirconia.

Production of Levoglucosenone from Pyrolysis of Cellulose Catalyzed by Solid Superacids

Selective production of levoglucosenone by catalytic pyrolysis of cellulose mixed with magnetic solid acid

Influence of Cellulose Ultrastructure on the Catalytic Pyrolysis for Selective Production of Levoglucosenone

Selective Production of Levoglucosenone from Catalytic Fast Pyrolysis of Biomass Mechanically Mixed with Solid Phosphoric Acid Catalysts

Influence of pyrolysis temperature and time on the cellulose fast pyrolysis products: Analytical Py-GC/MS study

Catalytic Pyrolysis of Cellulose with Sulfated Metal Oxides: A Promising Method for Obtaining High Yield of Light Furan Compounds

Preparation of aromatics from fast catalytic pyrolysis of cellulose over alkali-treated HZSM-5

Catalytic Fast Pyrolysis of Cellulose in a Microreactor System Using Hierarchical Zsm-5 Zeolites Treated with Various Alkalis

Preparation of levoglucosenone through sulfuric acid promoted pyrolysis of bagasse at low temperature.

High yield production of levoglucosan via catalytic pyrolysis of cellulose at low temperature

[Influence of ZSM-5(38)/Al-MCM-41 Composite Molecular Sieve Catalysts on Pyrolysis of Cellulose].

Synergistic effects for fast co-pyrolysis of strong-acid cation exchange resin and cellulose using Py-GC/MS

Study on the Pyrolysis of Cellulose for Bio-Oil with Mesoporous Molecular Sieve Catalysts.

Catalytic Fast Pyrolysis of Cellulose with Hzsm-5

Enhanced production of levoglucosenone from pretreatment assisted catalytic pyrolysis of waste paper

Selective Microwave‐Assisted Pyrolysis of Cellulose Towards Levoglucosenone with Clay Catalysts

Municipal sludge derived solid acids for levoglucosenone production via cellulose fast pyrolysis

On-line Catalytic Upgrading of Biomass Fast Pyrolysis Products