Abstract:A composite titania thin film consisted of quasi-aligned single-crystalline rutile nanorods embedded in sol-gel-derived anatase aggregates was fabricated and its photoelectrochemical behavior was studied in detail. A monolayer of nearly sing I e-crystal line rutile nanorods was first deposited on metallic Ti substrates through a controlled reaction between Ti and hydrogen peroxide. The gaps among the rutile nanorods were then filled with titania nanoparticles through a sol-gel dip-coating approach, which achieved a composite thin film of single-crystalline rutile nanorods embedded in anatase aggregates, after a subsequent thermal treatment at 723 K. The X-ray diffraction measurement revealed that the composite film with thickness of 180 nm contained anatase and rutile in a nearly 50:50 ratio. The UV-visible diffusive reflectance spectra estimated a band gap of 2.99 eV for the rutile monolayer and a slightly increased value of 3.03 eV for the composite film due to the embedding of the anatase nanoparticles. Photocurrent versus potential diagrams, photocurrent transient curves, and open-circuit potential measurement supported the fact that the anatase nanoparticles possessed better inherent photoelectrochemical properties than rutile. However, electrochemical impedance spectra characterization, together with photocurrent transient curves and open-circuit potential measurement, suggests that the single-crystalline rutile nanorods exhibited a higher electron-transfer rate. The combination of the two components in such an appropriate way enhanced significantly the charge separation effect arising from the anatase/rutile couple, which hence combined efficiently the "mixed crystal effect" and the "mixed morphological effect". A steady-state photocurrent more than double the simple sum of those generated by the two components alone was detected for the current composite film, which can be attributed to the single-crystalline rutile nanorods that provide channels for rapid electron transfer to the conductive Ti substrates under an applied bias potential. As a result, this study concludes that the present nanostructure magnified significantly the well-established mixed crystal effect, that is, an enhanced charge separation arising from a mixture of anatase and rutile.

Tungstate/titanate composite nanorod as an efficient visible light photo catalyst.

Preparation of WO<sub>x</sub>-TiO<sub>2</sub> and the Photocatalytic Activity under Visible Irradiation

Facile Fabrication of N-doped TiO2 Nanocatalyst with Superior Performance under Visible Light Irradiation

Single-crystal Heterostructured PbTiO3/CdS Nanorods with Enhanced Visible-Light-driven Photocatalytic Performance

Preparation of WO3/TiO2 nanorod composites and its photocatalytic activity

Fabrication of titania thin film with composite nanostructure and its ability to photodegrade rhodamine B in water

Nitrogen doped carbon quantum dots and GO modified WO3 nanosheets combination as an effective visible photo catalyst

Enhanced Photoelectrochemical Response of a Composite Titania Thin Film with Single-Crystalline Rutile Nanorods Embedded in Anatase Aggregates

Preparation of WO_3/TiO_2 Nanorod Composites and Its Photocatalytic Activity

TEMPLATED FABRICATION OF CHALCOCYANITE/TiO2 NANORODS WITH ENHANCED PHOTOCATALYTIC PROPERTY AND STABILITY IN MO DEGRADATION

Sputtering-Assisted Synthesis of Copper Oxide–Titanium Oxide Nanorods and Their Photoactive Performances

Study of new states in visible light active W, N co-doped TiO 2 photo catalyst

Rutile-phase TiO2@carbon core-shell nanowires and their photoactivation in visible light region

Synthesis and Characterization of Tungstite (WO3.H2O) Nanoleaves and Nanoribbons

Interfacial Growth of Activated Carbon on WO3 Nanoplates for Enhanced Photocatalytic Activity by Surface Plasmon Resonance

Novel Visible-Light-Active Tungstate and Molybdate Photocatalysts

TiO2 Nanoribbons/Carbon Nanotubes Composite with Enhanced Photocatalytic Activity; Fabrication, Characterization, and Application

Crystal Design and Photoactivity of TiO2 Nanorod Template Decorated with Nanostructured Bi2S3 Visible Light Sensitizer

The Fabrication and Characterization of Novel Carbon Doped TiO2nanotubes, Nanowires and Nanorods with High Visible Light Photocatalytic Activity

Significant Enhancement in the Photocatalytic Activity of N, W Co-Doped TiO2nanomaterials for Promising Environmental Applications

Cu-Co-codoped Titanate/tio2 Nanocomposite Thin Films for Enhanced Visible Light Absorption