Preparation of Coagulant from Red Mud and Semi-Product of Polyaluminum Chloride for Removal of Phosphate from Water

Fan Ni,Xianjia Peng,Ying Zhao,Jinsong He,Yiran Li,Zhaokun Luan
DOI: https://doi.org/10.5004/dwt.2012.2771
IF: 1.1
2012-01-01
Desalination and Water Treatment
Abstract:Traditionally, calcium aluminate, caustic soda, lime or aluminum slag was employed as alkali for basicity adjustment in the production of polyaluminum chloride (PACl). In this work, red mud (RM), a highly alkaline waste from alumina industry, was utilized instead of the traditional alkali. A composite coagulant (RMPACl) was prepared from RM and the semi-product of polyaluminum chloride (ACl). Important factors for preparation, such as RM/ACl ratio, reaction temperature and reaction time, were investigated and optimized to be as follows: RM/ACl ratio of 0.25 (w v(-1)), reaction temperature of 80 degrees C and reaction time of 4 h. The results of coagulation tests showed that RMPACl exhibited better performance than PACl for removal of phosphate. The optimum coagulation pH range of RMPACl was found to be 6.0-8.5. High phosphate removal efficiency (>94.9%) was achieved by dosing RMPACl at the dosage of 147.5 mg l(-1). Therefore, RMPACl was considered as a low-cost coagulant, which possessed a good coagulation performance for removal of phosphate.
What problem does this paper attempt to address?