Abstract:PurposeThe purpose of this paper is to present a novel method to design and fabricate aeroelastic wing models for wind tunnel tests based on stereolithography (SL). This method can ensure the structural similarity of both external and internal structures between models and prototypes.Design/methodology/approachAn aluminum wing‐box was selected as the prototype, and its natural modes were studied by FEA and scaled down to obtain the desired dynamic behavior data. According to similarity laws, the structurally similar model was designed through a sequential design procedure of dimensional scaling, stiffness optimization and mass optimization. An SL model was then fabricated, and its actual natural modes was tested and compared with the desired data of the prototype.FindingsThe first two natural frequencies of the model presented strong correlation with the desired data of the prototype. Both the external and internal structures of the model matched the prototype closely. The SL‐based method can significantly reduce the total mass and simplify the locating operations of balance‐weights. The cost and time for the fabrication were reduced significantly.Research limitations/implicationsFurther investigation into the material properties of SL resins including stiffness and damping behaviors due to layered process is recommended toward higher prediction accuracy. Wind tunnel tests are needed to study the in situ performance and durability of SL models.Originality/valueAlthough the paper takes a wing‐box as the study object, structurally similar SL models of entire wings can be obtained conveniently, benefiting from the low‐stiffness material properties of SL resins and the fabrication capacity to build complex structures of SL process. This paper enhances the versatility of using SL and other rapid prototyping processes to fabricate models to predict aeroelastic characteristics of aircraft.

Design and Analysis of a Wind Tunnel Test Model System for Gust Alleviation of Aeroelastic Aircraft

Aero-Elastic Wind Tunnel Test of A High Lighting Pole

Active Control and Wind Tunnel Test Verification of Multi-control Surfaces Wing for Gust Alleviation

Design of an Adaptive Gust Response Alleviation Control System: Simulations and Experiments

Effectively Analyzing Aeroelastic Model Empirical Design for Empennage Non-Lift Type Buffeting and Its Wind Tunnel Test Data

Dynamics, stability, and control of a four-cable mount system for wind tunnel test

Computational-Fluid-Dynamics-Based Aeroservoelastic Analysis for Gust Load Alleviation

Wind Tunnel Tests of an Aeroelastic Model of a Long-Span Transmission Tower

Geometrically Nonlinear Aeroelastic Stability Analysis and Wind Tunnel Test Validation of a Very Flexible Wing

A Smart Wing Model: From Design to Testing in a Wind Tunnel with a Turbulence Generator

A Reduced-Order-model-based Multiple-in Multiple-out Gust Alleviation Control Law Design Method in Transonic Flow

Gust Load Alleviation Control Strategies for Large Civil Aircraft through Wing Camber Technology

Aeroservoelastic Test of the Subsonic Ultra-Green Aircraft Research Truss-Braced Wing Model

Design of Flight Control Law of Gust Alleviation for Flexible Aircraft

Design and Fabrication of Stereolithography‐based Aeroelastic Wing Models

Real-Time Ground Aeroservoelastic Test for Slender Vehicles Based on Condensed Aerodynamic Force Loading

Stability analysis on an aeroelastic system for design of a flutter energy harvester

Performance evaluation of gust load alleviation systems for flexible aircraft via optimal control

Gust Response of Spanwise Morphing Wing by Simulation and Wind Tunnel Testing

The Study Of Aeroelastic Stability For Wind Turbine Blades

Aeroelastic Response and Active Control of Aircraft Wings Modeled as Thin-Walled Beams