Abstract:A unified robust structural, trim relationship and controller design methodology is presented for a MIMO aeroservoelastic system. It contains two stages in an iterative procedure: (1) robust structure and trim relationship optimization, and (2) robust controller design based on the optimal structure. The objective of the unified robust aeroservoelastic design is to obtain a minimum structure weight, under constraints on stability and performance specifications, and with structural and trim parameter uncertainties. Robustness is reflected in the fact that the weight variance is restricted to a small range and all the constraints are met when the design variables are uncertain. A genetic algorithm and sensitivity data were used in this open loop robust design stage. For the robust controller design, the well-known linear fractional transformation is used to interconnect uncertainty models for the structure and trim parameters with the other nominal aeroservoelastic model. Finally, the μ synthesis is applied to design a robust controller, which provides robust stability and instaneous closed-loop performance, under reasonable stress limitations. A flight vehicle with four control surfaces was tested to validate this methodology. After robust aeroservoelastic design, the aircraft is 3.62% heavier than the structure optimized by nominal method without consideration of uncertainty. However all the constraints are satisfied by the robust optimization, when the design variables are perturbed in a 5% uncertainty range. Hence, the structure is more robust to resist design variable uncertainties. The robust controller provided simultaneous high roll-rate performance and reduced the wing-root stress by 58.3% , when compared with the performance and stress of the openloop aeroelastic system.

Robust Aeroservoelastic Design with Structural and Trim Parameter Uncertainties

A Robust Aeroelastic Optimization Method of Structure and Trim for Air Vehicle with Multiple Control Surfaces

Robust Design Optimization of an Aerospace Vehicle Prolusion System

A Multivariable Robust Adaptive Control Scheme for Aero-engines

Robust Design Optimization of Flexible Backswept Wings with Structural Uncertainties

Robust model reference sliding mode control for flexible air-breathing hypersonic vehicle

Robust aeroservoelastic stability margin analysis using the structured singular value

Robust optimization of control command for aerospace vehicles with aerodynamic uncertainty

Robust structural design optimization of flexible backswept wings

Robust Attitude Control Design for a Hypersonic Vehicle with Multi-Constraints

LMI–based robust controller design approach in aircraft multidisciplinary design optimization problem

Design of Autopilot for Hypersonic Vehicle Based on Robust Control Theory

Two Degree-of-Freedom Μ Controller with Low Conservativeness for Aeroengine

Adding Robustness to Good Command Response of Aircraft Longitudinal Flight Control System

Aeroservoelastic Robustic Stability Analysis for Flight Vehicles with Parametric Perturbation

Robust Stall Flutter Suppression Using ℋ2/ℋ∞ Control

Aeroelastic Optimization Design for Wing with Maneuver Load Uncertainties

Robust Control for Hypersonic Vehicles with Parametric and Unstructured Uncertainties

Robust Optimal Controller Design for Generic Hypersonic Vehicles

Robust Stall Flutter Suppression Using H-2/H-Infinity Control

Aeroservoelastic model based active control for large civil aircraft