Abstract:Experimental research was carried out to investigate the characteristics of tip vortex cavitation (TVC) caused by tip vortex in an oscillating hydrofoil. Shanghai Shipping and Research Institute's looped cavitation tunnel served as the site of the experiments. The hydrofoil used as the test was NACA (National Advisory Committee for Aeronautics) 63820. Two high-speed cameras, one torque sensor, and six hydrophones were employed to capture the cavitation patterns, the torque exerted on the hydrofoil, and the cavitation noise, respectively. The cavitation flow under static angle of attack (AoA) and the dynamic AoA have all been investigated in order to have a better knowledge of the differences between the TVC surrounding these two conditions. The AoA of 8.5°, 10°, and 14.5° and the AoA range of 1.8°–16° were selected for the static condition research and the dynamic condition study, respectively. A tip vortex flow was created between the tip of the stationary hydrofoil and the ceiling of the tunnel test section. To investigate the impact of the cavitation number on the growth of TVC surrounding the pitching hydrofoil, various pressure environments were built up. As for the experiment environment, cavitation numbers 2.47, 2.00, and 1.66 were used. The results indicate: (1) under static conditions, decreasing cavitation and increasing AoA lead to increased stability and topological complexity of TVC. (2) Comparing and analyzing cavitation patterns during the ascending, static, and descending processes reveal that the strongest cavitation intensity during the descending process, followed by static conditions, with the least intensity during the ascending process. (3) The frequency properties under pitching motion include those of each static AoA condition, although the acoustic characteristic of higher AoA has a stronger influence on that of dynamic condition.

A High-Speed Towing Tank for Hydrodynamics and Cavitation Experiments

Research on Hydrodynamics of Trans-Media Vehicles Considering Underwater Time-Varying Attitudes

Dynamic Response of Deep-Sea Trawl System During Towing Process

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Experimental Research for the Influence of Stern Towing Force on a Planing Hull in the Towed System

Experiment Investigation of the Tip Vortex Cavitation Around a Pitching Hydrofoil

Simulation of High-Speed Vessel Waves Based on 2d+t SPH Method

Design & automation of a small-scale towing tank for flow visualization

Design Method of Water Jet Pump Towards High Cavitation Performances

Large Eddy Simulation Investigation of Micro-Vortex Generator Control Effect on Early Stage Sheet Cavitation

On the Validation of the Cavitation Model Considering the Thermodynamic Effect of Cavitating Flow

Numerical research on the high-speed water entry trajectories of AUVs with asymmetric nose shapes

Study on a novel two-part underwater towed system for near-surface towed vehicle test

Motion characteristics and T-foil based optimization of marine towed-cage in swell

Experimental Investigation of High Speed Cross-Domain Vehicles with Hydrofoil

A Cavitation Model Considering Thermodynamic and Viscosity Effects

Hydrodynamic Investigations of a Cross-Domain Vehicle with the Capability of High-Speed Cruising on Water Surface

Analysis of Ventilated Cavitation Around A Cylinder Vehicle with Nature Cavitation Using A New Simulation Method

Virtual Replica of a Towing Tank Experiment to Determine the Kelvin Half-Angle of a Ship in Restricted Water

Seakeeping investigations of a cross-domain vehicle with the capability of high-speed cruising in waves

Experimental Study on the Hydrodynamic Behavior for a Novel Compound Anti-Vibration Submerged Floating Tunnel System