Abstract:For a fiber optic gyroscope, thermal deformation of the fiber coil can introduce additional thermal-induced phase errors, commonly referred to as thermal errors. Implementing effective thermal error compensation techniques is crucial to addressing this issue. These techniques operate based on the real-time sensing of thermal errors and subsequent correction within the output signal. Given the challenge of directly isolating thermal errors from the gyroscope’s output signal, predicting thermal errors based on temperature becomes necessary. To establish a mathematical model correlating the temperature and thermal errors, this study measured synchronized data of phase errors and angular velocity for the fiber coil under various temperature conditions, aiming to model it using data-driven methods. However, due to the difficulty of conducting tests and the limited number of data samples, direct engagement in data-driven modeling poses a risk of severe overfitting. To overcome this challenge, we propose a modeling algorithm that effectively integrates theoretical models with data, referred to as the TD-model in this paper. Initially, a theoretical analysis of the phase errors caused by thermal deformation of the fiber coil is performed. Subsequently, critical parameters, such as the thermal expansion coefficient, are determined, leading to the establishment of a theoretical model. Finally, the theoretical analysis model is incorporated as a regularization term and combined with the test data to jointly participate in the regression of model coefficients. Through experimental comparative analysis, it is shown that, relative to ordinary regression models, the TD-model effectively mitigates overfitting caused by the limited number of samples, resulting in a substantial 58% improvement in predictive accuracy.

Thermal Induced Nonreciprocity In Fiber Optic Sensors Based On Sagnac Interferometer

Nonreciprocal Phase Shift Caused by Magnetic-Thermal Coupling of A Polarization Maintaining Fiber Optic Gyroscope

Temperature Modeling of Modulation Phase Error in the Integrated Optical Chip for Closed-Loop Interferometric Fiber Optic Gyroscope

Nonreciprocal Phase Error Caused by Orthogonal Magnetic Field in a Polarization-Maintaining Fiber-Optic Gyro

Nonreciprocity in Single-Mode Fiber Coil Induced by Orthogonal Magnetic Field

Research on the Temperature Characteristic of Magnetic Sensor in the Magnetic Drift Compensation Fiber-Optic Gyroscope

Study of Wavelength Temperature Stability of Multifunctional Integrated Optical Chips Applied on Fiber Optic Gyroscopes

Simulation Analysis of Temperature Effects on All-Fiber Optic Current Sensor

Type of Non-reciprocity in Fiber Sagnac Interferometer Induced by Geometric Phases

A novel compensation fiber coil for eliminating Sagnac Effect in fiber optic current sensor

Compensation of thermal strain induced polarization nonreciprocity in dual-polarization fiber optic gyroscope.

Bias Error and Its Thermal Drift Due to Fiber Birefringence in Interferometric Fiber-Optic Gyroscopes

Experimental Research on an Optical Fiber Temperature and Stress Sensor Based on the Time Offset

Optical Kerr Effect in Phase Modulation Spectroscopy Resonator Fiber Optic Gyro

Experimental Study of Fiber-Optic Temperature Sensor Based on Dual FSIs

Modeling and Prediction of Thermal Deformation Errors in Fiber Optic Gyroscopes Based on the TD-Model

Optical Fiber Temperature and Torsion Sensor Based on Lyot-Sagnac Interferometer.

Experimental study on a parallel optical fiber Sagnac loops-based sensor with the advantages of both high sensitivity and ultra-wide measurement range

A Sensitivity Difference Approach to Overcome Temperature Influence on a Fiber Optic Force Sensor with a Pair of FBGs

Thermal phase noise in giant interferometric fiber optic gyroscopes

Thermal Effect of Fiber Interferometer Using Coaxial Structure