Abstract:Balanced charge carrier and appropriate exciton confinement are considered as the key factors for the realization of highly efficient and stable organic light-emitting devices (OLEDs). An effective way to reach a loss free hole-electron recombination and exciton leakage is to use suitable electron transporting layers (ETLs). To investigate the influence of triplet energy and electron transporting properties of ETLs on the performance of iridium complex yellow phosphorescent OLEDs, we fabricated three devices based on bis[2-(4-tert-butylphenyl)benzothiazolato-N,C2']iridium (acetylacetonate) [(t-bt)(2)Ir(acac)] doped 4,4'-bis(carbazol-9-yl)biphenyl (CBP) host by using 2,9-dimethyl-4,7-diphenyl-1,10-phenanthroline (BCP), 1,3,5-tris(N-phenylbenzimidazole-2-yl)benzene (TPBi), and 4,7-diphyenyl-1,10-phenanthroline (BPhen) as ETLs, respectively. It was found that there was no apparent correlation between the device efficiency and the triplet energy of ETLs. Instead, device efficiency was determined by the electron mobility of ETLs only. With an optimized device using BPhen as ETL, a power efficiency of 23.1 lm/W and a current efficiency of 28.0 cd/A at 0.08 mA/cm(2) were achieved, which was much higher than that of the control devices (7.5 lm/W for BCP-device and 8.5 lm/W for TPBi-device). The improved efficiency was attributed to that BPhen had the highest electron mobility and provided better charge balance in the hole-dominant devices. Moreover, the EL spectra of three devices showed no obvious difference with a light emission from iridium complex peaked at 562 nm and a shoulder peak at 600 nm. This indicated that no matter BCP, TPBi or BPhen acted as ETLs, the (t-bt)(2)Ir(acac) triplet exciton can be confined within the emissive layer effectively.

Different Configurations of Phosphorescent Yellow Emissive Layer in White Organic Light-Emitting Device

White polymer phosphorescent light-emitting devices with a new yellow-emitting iridium complex doped into polyfluorene

Effect of two yellow delta-emitting layers on device performance of phosphorescent white organic light-emitting devices

High-Efficiency White Organic Light-Emitting Devices with A Non-Doped Yellow Phosphorescent Emissive Layer

Effect of Charge Carrier Transport Property and Energy Level of Host Material on Phosphorescent White Organic Light-Emitting Device

Effect Of A Delta-Doping Green Emitting Layer In White Organic Light-Emitting Device

Optimization of Yellow Phosphorescent Organic Light-Emitting Devices Based on Triplet Exciton Diffusion Length

High efficiency organic light-emitting diodes with yellow phosphorescent emission based on a novel iridium complex

Adjusting White Oleds With Yellow Light Emission Phosphor Dye And Ultrathin Npb Layer Structure

High-efficiency White Phosphorescent Organic Light-Emitting Diodes

Influence of Dopant Concentration on Electroluminescent Performance of Organic White-Light-Emitting Device with Double-Emissive-Layered Structure

Effect Of Triplet Energy And Transporting Property Of Electron Transporting Material On Iridium Complex Yellow Phosphorescent Organic Light-Emitting Devices

Effects of Ultrathin Layer Thickness of Iridium Complex Phosphor (T-Bt)2ir(acac)on the Performance of Organic Light Emitting Devices

Highly efficient yellow organic light-emitting diodes with slow efficiency roll-off by mixing red and green emissions

Chromatic-stability White Organic Light Emitting Diodes Based on Phosphorescence Doped Electron Transport Layer

Efficient white organic light-emitting devices using a thin 4,4′-bis(2,2′-diphenylvinyl)-1,1′-diphenyl layer

Properties of non-doped organic light-emitting devices based on an ultrathin iridium complex phosphor layer

Hybrid white organic light-emitting diodes with improved color stability and negligible efficiency roll-off based on blue fluorescence and yellow phosphorescence

Electroluminescence of Organic Light-Emitting Diodes Consisting of an Undoped (pbi)2ir(acac) Phosphorescent Layer

High-efficiency white organic light-emitting diodes based on phosphorescent iridium complex and 4,4′-Bis[N-1-napthyl-N-phenyl-amino]biphenyl emitters

Effects of the Emission Layer Structure on the Electroluminescence Performance of the White Organic Light Emitting Diodes Based on Thermally Activated Delayed Fluorescence Emitters