Abstract:After years of development from a concept to early experimental stage, X-ray Deformable Mirrors (XDMs) are used in many synchrotron/free-electron laser facilities as a standard x-ray optics tool. XDM is becoming an integral part of the present and future large x-ray and EUV projects and will be essential in exploiting the full potential of the new sources currently under construction. The main objective of using XDMs is to correct wavefront errors or to enable variable focus beam sizes at the sample. Due to the coupling among the N actuators of a DM, it is usually necessary to perform a calibration or training process to drive the DM into the target shape. Commonly, in order to optimize the actuators settings to minimize slope/height errors, an initial measurement need to be collected, with all actuators set to 0, and then either N or 2N measurements are necessary learn each actuator behavior sequentially. In total, it means that N+1 or 2N+1 scans are required to perform this learning process. When the actuators number N is important and the actuator response or the necessary metrology is slow then this learning process can be time consuming. In this work, we present a fast and accurate method to drive an x-ray active bimorph mirror to a target shape with only 3 or 4 measurements. Instead of sequentially measuring and calculating the influence functions of all actuators and then predicting the voltages needed for any desired shape, the metrology data are directly used to "guide" the mirror from its current status towards the particular target slope/height via iterative compensations. The feedback for the iteration process is the discrepancy in curvature calculated by using B-spline fitting of the measured height/slope data. In this paper, the feasibility of this simple and effective approach is demonstrated with experiments.

New Unimorph Deformable Mirror For Laser Beam Shaping

Research of an Adaptive Micro-Mirror Based on Micro-Opto-Electro-Mechanical- System

Wavefront Correction by a Low-Cost Deformable Mirror Group in a Small-Aperture-beam Fiber Laser.

Intracavity Deformable Mirror for Beam Quality Improvement and Power Enhancement of a Passively Q-switched Laser

Characterization of White-Light Non-Diffracting Beams Generated Using a Deformable Mirror.

Design Beam Shapers with Double Freeform Surfaces to Form a Desired Wavefront with Prescribed Illumination Pattern by Solving a Monge-Ampère Type Equation

Structure and Closed-Loop Control of A Novel Compact Deformable Mirror for Wavefront Correction in A High Power Laser System

Research on PZT-based Deformable Micro-mirror Array in Adaptive Optics

Trans-reflection Thermal Driven Deformable Mirror with Flexible Bonding in High Energy Laser System

Simulational and Experimental Investigation on the Actuator-Corresponding High-Frequency Aberration of the Piezoelectric Stacked Array Deformable Mirror

Double Freeform Surfaces Design for Laser Beam Shaping with Monge–Ampère Equation Method

A Thermo-Field Bimetal Deformable Mirror for Wavefront Correction in High Power Lasers

Over Compensation Algorithm for Laser Beam Shaping Using a Deformable Freeform Mirror

Development of A Novel Three-Dimensional Deformable Mirror with Removable Influence Functions for High Precision Wavefront Correction in Adaptive Optics System

Wavefront Shaping by A Small-Aperture Deformable Mirror in the Front Stage for High-Power Laser Systems

New Scheme to Control X-Ray Deformable Mirrors

Simulation and Experimental Investigation on the Wavefront Correction Performance of a Dual Magnetic Connection Deformable Mirror under High-Power Laser Irradiation

Membrane based Deformable Mirror: Intrinsic aberrations and alignment issues

Control X-Ray Deformable Mirrors with Few Measurements

High-Precision Assembly Process Of Large-Aperture Laser Transport Mirror In The High-Energy Laser Facility

Tailoring Freeform Beam-Shaping Lenses for Edge-Emitting Lasers