Abstract:Dynamic Partially Reconfiguration (DPR) designs provide additional benefits compared to traditional FPGA application. However, due to the lack of support from automatic design tools in current design flow, designers have to manually define the dimensions and positions of Partially Reconfigurable Regions (PR Regions). The following fine-grained placement for system modules is also limited because it takes the floorplanning result as a rigid region constraint. Therefore, the manual floorplanning is laborious and may lead to inferior fine-grained placement results. In this paper, we propose to integrate PR Region floorplanning with fine-grained placement to achieve the global optimization of the whole DPR system. Effective strategies for tuning PR Region floorplanning and apposite analytical evaluation models are customized for DPR designs to handle the co-optimization for both PR Regions and static region. Not only practical reconfiguration cost and specific reconfiguration constraints for DPR system are considered, but also the congestion estimation can be relaxed by our approach. Especially, we established a two-stage stochastic optimization framework which handles different objectives in different optimization stages so that automated floorplanning and global optimization can be achieved in reasonable time. Experimental results demonstrate that due to the flexibility benefit from the unification of PR Region floorplanning and fine-grained placement, our approach can improve 20.9% on critical path delay, 24% on reconfiguration delay, 12% on congestion, and 8.7% on wire length compared to current DPR design method.

A NoC Architecture for High-Speed Dynamic Partial Reconfiguration

An NoC Structure Suitable for Dynamically and Partially Reconfigurable System

A High-Performance, Low-Area Reconfiguration Controller For Network-On-Chip-Based Partial Dynamically Reconfigurable System-On-Chip Designs

A Hardware/Software Co-Design Flow for Dynamic Partial Reconfiguration

Amorphous Dynamic Partial Reconfiguration with Flexible Boundaries to Remove Fragmentation

Adaptive Selection and Clustering of Partial Reconfiguration Modules for Modern FPGA Design Flow.

PDPR: Fine-Grained Placement for Dynamic Partially Reconfigurable FPGAs

Achieving Flexible Global Reconfiguration in NoCs Using Reconfigurable Rings.

HW/SW Partitioning for Region-Based Dynamic Partial Reconfigurable FPGAs

Homogeneous NoC-based FPGA: The Foundation for Virtual FPGA

Data dependency aware prefetch scheduling for Dynamic Partial reconfigurable designs

Virtualization Architecture for NoC-based Reconfigurable Systems

Reconfigurable Designs for Networking Silicon.

Memory-aware Partitioning, Scheduling, and Floorplanning for Partially Dynamically Reconfigurable Systems.

An FPGA-based Accelerator for Deep Neural Network with Novel Reconfigurable Architecture.

A Traffic-Aware Adaptive Routing Algorithm on A Highly Reconfigurable Network-On-Chip Architecture

Load-Aware Dynamic Partial Reconfiguration Implementation of Crossbar Scheduler

Design and implementation of dynamic and partial reconfigurable high-performance computing using FPGA

Flexible Updating of Internet of Things Computing Functions through Optimizing Dynamic Partial Reconfiguration

High-performance Communication Architecture Supporting Dynamic Reconfigurable SoC

Resource Partitioning and Application Scheduling with Module Merging on Dynamically and Partially Reconfigurable FPGAs