Abstract:The IEC 62271-100 international standard states that the mechanical endurance test is a mandatory test for a circuit breaker (CB) to verify its mechanical performance. The objective of this paper is to demonstrate the failure modes of three mechanical components and to show how they can be improved to extend the mechanical endurance of a prototype 126 kV single-break vacuum circuit breaker (VCB). The three mechanical components are: a pin (stainless steel: 20CrNiMo) contained in a contact spring component, a joint bearing (stainless steel: 1Cr18Ni9Ti), and an inter-locking pawl (steel: Q235). All three components showed low-cycle metallic fatigue failure modes, which presented as deformation and metallic crack initiation and propagation. During mechanical endurance operations (i.e., closing and opening operations under no load conditions), the pin in the contact spring component fractured after approximately 178 operations; the joint bearing deformed greatly and fractured after about 1,500 operations; and the inter-locking pawl fractured after approximately 2,100 operations. Based on the theory of multi-body system dynamics and the S-N characteristics of the metal material applied in each case, the failure modes and fatigue lives of the three failed components and improved versions of their geometries were analyzed, respectively. Both the simulation results and the experimental results for the mechanical endurances of the improved component geometries offered greater confidence in the mechanical reliability of the 126 kV VCB: after 1,500 operations, the improved pin worked well, with no deformation or initial cracking; after 2,000 operations, small deformations were observed on both terminals, but with no initial cracking; and after 2,000 operations, the joint bearing and the inter-locking pawl both continued to work well, with no deformation or initial cracking.

Vibration Characteristics During Mechanism Endurance Test of a High Voltage Circuit Breaker

GIS Mechanical State Identification and Defect Diagnosis Technology Based on Self-Excited Vibration of Assembled Circuit Breaker

Vibration Signal Analysis of Hydraulic Operating Mechanism for High Voltage Circuit Breaker Based on EMD Method

Mechanical Condition Monitoring for High Voltage Circuit Breakers

Condition Monitoring Of Vacuum Circuit Breakers Using Vibration Analysis

A New Processing Method of Mechanical Vibration Signals from High-Voltage Circuit Breakers' Monitoring

Processing of Mechanical Vibration Signals of High- Voltage Circuit Breakers Based on Fractal Theory

High voltage circuit breaker dynamics simulation and mechanical state recognition

Analysis of Mechanical Characteristics Force Signal of High Voltage Circuit Breaker

Research Of Typical Mechanical Fault Diagnosis For Hv Circuit Breaker Based On Vibration Signals

Simulation and experimental research on vibration characteristics forhigh voltage circuit breaker with hydraulic operating mechanisms

Characteristic Analysis of High Voltage Circuit Breaker with Hydraulic Operating Mechanism

Vacuum Circuit Breaker Closing Time Key Moments Detection via Vibration Monitoring: A Run-to-Failure Study

On-line Monitoring Method for Mechanical Characteristics of Vacuum Circuit Breakers

Mechanical Reliability of a 126 Kv Single-Break Vacuum Circuit Breaker

Analysis of Characteristics of Vibration Signals in High-Voltage Circuit Breakers Based on Phase Space Reconstruction

Research on Fault Diagnosis Technology of AC Medium Voltage Vacuum Circuit Breaker Based on Wavelet Packet

Research on Fault Diagnosis Method Based on Vibration Signal for High Voltage Circuit Breaker

Electromagnet Operation Characteristic in High-Voltage Circuit Breakers

A Mechanical Defect Localization and Identification Method for High-Voltage Circuit Breakers Based on the Segmentation of Vibration Signals and Extraction of Chaotic Features

Mechanical State Detection of GIS Circuit BreakerBased on Vibration Characteristics