Abstract:An IMC with SSVPWM on rectifier side and a BCPWM technique on the inverter side leads to the maximization of the DC‐link voltage, reduction in switching losses and THD of the load voltage. Simulation results confirm the effectiveness of this approach, with real‐time implementation validated using the OPAL‐RT simulator. This article presents a comprehensive investigation into the improved operation of an in‐direct matrix converter (IMC) through the application of improved pulse width modulation (PWM) techniques. Matrix converters (MCs) draw a discontinuous and distorted input current from the AC source, reducing the input power factor and increasing harmonics. The primary objectives of this work are to maximize the DC‐link voltage and improve source current while simultaneously minimizing switching losses and the total harmonic distortion (THD) of the load voltage, thereby improving power quality standards. To achieve these goals, a symmetrical space vector PWM technique (SSVPWM) is employed on the rectifier side, and an improved bus‐clamping PWM technique (BCPWM) is implemented on the inverter side. By strategically controlling the switching patterns, the DC‐link voltage is maximized while adhering to the voltage and current constraints of the switching devices, which improves the input power factor and hence the overall power quality. Additionally, this technique optimizes the operation of the IMC, leads to a reduction of current ripple, and reduces switching losses, thereby leading to higher efficiency. The core principle behind this research lies in the decoupled control of the rectifier and inverter stages, allowing for independent optimization and maximum system performance. By carefully manipulating the modulation indices, the harmonic content in the output voltage is significantly minimized which is vital for applications requiring a high‐quality and low‐distortion power supply. Simulation studies substantiate the efficacy of the independent control approach, showcasing improvements in DC‐link voltage maximization, switching loss reduction, and reduced output voltage THD. Furthermore, the validation of the real‐time implementation of this study was carried out making use of the OPAL‐RT (OP4510) real‐time simulator.

Input Power Factor Control Of Rb-Igbt Based Indirect Matrix Converter

Analysis and Control of Input Power Factor in Indirect Matrix Converter

Three-phase Current-Source Buck Type PFC Converter with Reverse-Blocking IGBTs

Control of A Stand-Alone Wind Energy Conversion System Via A Third-Harmonic Injection Indirect Matrix Converter

Input Power Factor Control of Two-stage Matrix Converter

Three-Phase to Single-Phase Matrix Converter Using RB-IGBT

A Method of Power Loss Calculation for RB-IGBT Matrix Converter

Utility Power Supply Based on Indirect Matrix Converter for Electromagnetic Stirrer

Control of Indirect Matrix Converter Based on Finite State Machine

A Novel Commutation Method of Matrix Converter Fed Induction Motor Drive Using RB-IGBT

Analysis of Efficiency and Harmonics for Reverse Blocking Igbt Matrix Converters

Rb-Igbt Gate Drive Circuit And Its Application In Two-Stage Matrix Converter

Improved Control on the Complementary Half Controlled Three Phase PWM Boost Rectifier

A Three-Level T-Type Indirect Matrix Converter Based on the Third-Harmonic Injection Technique

Topology and Modulation for a New Indirect Matrix Converter to Reduce the Common-Mode Voltage

Topology and Modulation Scheme of a Three-Level Third-Harmonic Injection Indirect Matrix Converter

Enhancing Performance of In‐Direct Matrix Converter Through Improved PWM Techniques for Reduced Switching Loss and Optimal DC‐Link Voltage

Direct Power Control for Dfig under Unbalanced and Harmonically Distorted Grid Voltage in Stationary Frame

Performance Improvements For Matrix Converter Based On Reverse Blocking Igbt

Indirect Current Control Adjustable Power Factor Current Source PWM Converter

Novel improvements for matrix converter fed adjustable speed drive system