Abstract:Due to the large number of design variables that can be present in complex systems incorporating visco-elastic damping, this work examines the application of genetic algorithms in optimizing the response of these structures. To demonstrate the applicability of genetic algorithms (GAs), the approach is applied to a simple viscoelastically damped constrained-layer beam. To that end, a finite element model (FEM) derived by Zapfe, which was based on Rao's formulation, was used for a beam with constrained-layer damping. Then, a genetic algorithm is applied to simultaneously determine the thicknesses of the viscoelastic damping layer and the constraining layer that provide the best response. While the targeted response is ultimately at the discretion of the designer, a few different choices for the fitness function are shown along with their corresponding impact on the vibratory response. By integrating the FEM code within the GA routine, it is easier to include the frequency-dependence of both the shear modulus and the loss factors for the viscoelastic layer. Examples are provided to demonstrate the capabilities of the method. It is shown that while a multi-mode optimization target provides significant reductions, the response for that configuration is inferior to the response when only single-mode reduction is considered. The results also reveal that the optimum configuration has a lower response level than when a thick layer of damping material is used. By demonstrating the applicability of GA for a simple beam structure, the approach can be extended to more complex damped structures.

Integrated design of control/structural systems based on genetic algorithm

Tuned Mass Damper Parameters Design for Structural Systems Via Linear Matrix Inequality and Genetic Algorithm

Integrated Optimization of Structure and Control Systems for Interconnected Building Structures Subjected to Earthquake

Integrated Optimization Design of Continuum Structure Topology Optimization/control Based on Genetic Algorithm

Integrated Multiobjective Optimal Design for Active Control System Based on Genetic Algorithm

Integrated Optimization of Structural Topology and Control for Piezoelectric Smart Plate Based on Genetic Algorithm

Optimal Design of Structural Dynamic Boundary Conditions Based on Topology Optimization Method

Research of Active Vibration Control Optimization Based on Genetic Algorithm

Integrated Optimization of Structural Topology and Control for Piezoelectric Smart Trusses with Interval Variables

A SYNTHETIC ANALYSIS ON DESIGN OF OPTIMUM CONTROL FOR AN OPTIMIZED INTELLIGENT STRUCTURE

Active Vibration Control Optimization Based on NSGA-II

Design of Fuzzy Controller for Smart Structures Using Genetic Algorithms

Integrated Design of Inelastic Controlled Structural Systems

Control–structural design optimization for vibration of piezoelectric intelligent truss structures

Design Optimization for Vibration Reduction of Viscoelastic Damped Structures Using Genetic Algorithms

Research on Optimal Damping Distribution of Adjacent Structures Based on a Genetic Algorithm

Integrated Structural and Control Design for Piezoelectric Adaptive Truss

Optimum Spatiall Placement of Dampers in Vibration Controlled Structures Based on Genetic Algorithms

Integrated-Optimal Design Of Airplane And Flight Control Using Genetic Algorithms

Design for beam-balanced system controller based on chaos genetic algorithm

Structural Active Control Based on Eigenstructure Assignment and Its Simulations