Abstract:A linear failure criterion is widely used in slope stability analyses. However, the strength envelope of almost all geomaterials has the nature of nonlinearity. This paper computes rigorous upper bounds on slope stability factors under the condition of plane strain with a nonlinear yield criterion by employing the upper bound theorem of plasticity. A stability factor (or a limit load) computed using a linear Mohr-Coulomb (MC) failure criterion which circumscribes the actual nonlinear failure criterion is an upper bound value of the actual stability factor (or limit load). In this paper, an improved method using a generalized tangential technique to approximate a nonlinear failure criterion is proposed to estimate the stability factor of a slope on the basis of the upper bound theorem of plasticity. Using the generalized tangential technique, the curve of the nonlinear failure criterion is simplified as a set of straight lines according to the linear MC failure criterion. The straight line is tangential to the curve of the nonlinear failure criterion. The set of straight lines of the linear MC failure criterion is employed to formulate the slope stability problem as a classical optimization problem. The objective function formulated in this way is minimized with respect to the location of sliding body center and the location of tangency point. Two typical slope stability problems (a homogeneous soil slope with two slope angles and a vertical cut slope with a tension crack) are analyzed using the proposed method. For the soil slope with two slope angles, the computed results are compared with published solutions by others. The comparison shows that the proposed method gives reasonable and consistent values of the stability factor of the slope. For the vertical cut slope with a tension crack, a statically admissible stress field is constructed for the slope. The stress field does not violate the nonlinear failure criterion. Lower bound solutions are obtained by satisfying stress equilibrium conditions. The upper bound solutions obtained from the proposed method are equal to the lower bound solutions for the vertical cut slope. The agreement further supports the validation of the proposed approach. The influences of the strength parameters in the nonlinear criterion on the stability of slopes are also studied and discussed in this paper.

Numerical Study of Plastic Strains on Slope Instability

Study on the Crack Mechanism and Back Analysis of Mechanics Parameters of the Soil Slope in the New Area of MaGang

Numerical stability assessment of a mining slope using the synthetic rock mass modeling approach and strength reduction technique

Evaluating Slope Stability with 3D Limit Equilibrium Technique and Its Application to Landfill in China

Stability Analysis of Dump Slope Based on FEM Strength Reduction Method

Numerical Simulation of Slope Stability during Underground Excavation Using the Lagrange Element Strength Reduction Method

Large Deformation Finite Element Analysis on Excavated Slopes

Research on upper bound limit analysis of slope stability in open-pit mine based on least square principle

The Analysis of Slope Stability by Strength Reduction FEM Based on ABAQUS Software

Stability Analysis of Coal Mine Tunnel Based on Strength Reduction Theory and ANSYS

Destabilization Mechanism and Prevention Technology of Open-Pit Mine Slope with Soft Interlayer Under Rainfall Infiltration Conditions: A Case Study

A Novel Strength Reduction Method for a Slope Stability Assessment Based on a Finite Element Method

Novel Strength Reduction Numerical Method to Analyse the Stability of a Fractured Rock Slope from Mesoscale Failure

Slope stability analysis based on a multigrid method using a nonlinear 3D finite element model

Numerical analysis of the precursory information of slope instability process with constant resistance bolt

Failure mechanism and stability analysis of an open-pit slope under excavation unloading conditions

Stability analysis of open-pit gold mine slopes and optimization of mining scheme in Inner Mongolia, China

Numerical Modeling of 3D Slopes with Weak Zones by Random Field and Finite Elements

Slope Stability Analysis with Nonlinear Failure Criterion

Stability of Slope with the Weak Structural Plane Based on 2-D Nonlinear Finite Element Method

Stability analysis of slope in strain-softening soils using local arc-length solution scheme