Abstract:Programmable active bandpass filters (BPFs) have been designed in a chip-scale heterogeneous integration technology, which intimately integrates InP HBTs on a deep scaled CMOS technology. Therefore, the active BPF can leverage both high performance of InP HBT and high density and programmability of CMOS. Two BPF prototypes, consisting of a programmable gain amplifier (PGA), a fifth- or third-order BPF core, and a buffer, have been designed and fabricated. The BPF center frequency can be switched from 0.8 to 2.2 GHz with 150-MHz passband and delivers > 55-dB out-of-band (OOB) rejection for the fifth-order one. Four gain steps: 0, 6, 12, and 16 dB, are enabled by the front PGA to trade off noise and linearity performances. Due to the > 300-GHz f T of InP HBTs, the BPF cores can leverage active-RC architecture for high linearity owing to the close-loop implementation. The fifth-order BPF prototype occupies a 1.5 × 1.02 mm2 area together with pads and draws 106/121 mA from a 3.3-V power supply for 0.8/2.2-GHz bands, respectively, which demonstrates OOB output third-order intercept points (OIP3s) of 22.69/21.25 dBm for 0.8/2.2-GHz bands at the high gain mode. The measurement results suggest the fifth-order BPF core achieves 36.69/35.25-dBm OOB OIP3s. In addition, the designed third-order programmable BPF has been successfully used as a technology yield vehicle to assist the BiCMOS technology development.

A Programmable Low-Pass Filter with Adaptive Miller Compensation for Zero-if Transceiver

A 1.3–1.7-Ghz $Q$ -Enhanced Resonator-Based High-IF Bandpass Filter with 1.5%–67% Tunable Fractional Bandwidth in 65-Nm CMOS Process

A 5th order 0.8/2.4 GHz programmable active band pass filter for power DAC applications

A CMOS 1.3-1.7GHz Q-Enhanced LC Band-pass RF Filter with 1.5-67% Tunable Fractional Bandwidth

A 0.8/2.4 GHz Tunable Active Band Pass Filter in InP/Si BiCMOS Technology

0.8/2.2-Ghz Programmable Active Bandpass Filters in InP/Si BiCMOS Technology

Scalable, Low-power and High-performance Active-RC Complex Band-Pass/Low-Pass Filter with Automatic Frequency Tuning Applied to the Internet of Things

A CMOS Programmable Fourth-Order Butterworth Active-RC Low-Pass Filter

A 2.3mA 240-to-500MHz 6th-order active-RC low-pass filter for ultra-wideband transceiver

A Very Linear Low-Pass Filter with Automatic Frequency Tuning

A 5.7mw +30dbm IIP3, Tunable Active-RC LPF in 40nm CMOS

A 1.8-V, 5-Ma Reconfigurable Analog Baseband Circuit for Low-if Multi-Mode Multi-Band Receivers

Design on Low-pass Filter Based on TD-SCDMA

A Configurable Active-Rc Filter for Half-Duplex Transceiver

An Active-RC Complex Filter with Mixed Signal Tuning System for Low-IF Receiver

Reconfigurable Low Pass Filter with Automatic Frequency Tuning for WCDMA and GSM Application.

Low-Power IF Complex Filter with on-Chip Tuning Circuit Based on PLL

A Baseband Lpf for Gsm, Td-Scdma and Wcdma Multi-Mode Transmitters

A 20–80 MHz Continuously Tunable Gm-C Low-Pass Filter for Ultra-Low Power WBAN Receiver Front-End

A Reconfigurable Low Power Filter in 65 nm CMOS for Multi-standard Transmitters