Abstract:A detailed understanding of the cell adhesion on polymeric surfaces is required to improve the performance of biomaterials. Quartz crystal microbalance with dissipation (QCM-D) as a surface-sensitive technique has the advantage of label-free and real-time monitoring of the cell-polymer interface, providing distinct signal patterns for cell-polymer interactions. In this study, QCM-D was used to monitor human fetal osteoblastic (hFOB) cell adhesion onto polycaprolactone (PCL) and chitosan (CH) homopolymer films as well as their blend films (75:25 and 25:75). Complementary cell culture assays were performed to verify the findings of QCM-D. The thin polymer films were successfully prepared by spin-coating, and relevant properties, i.e., surface morphology, ζ-potential, wettability, film swelling, and fibrinogen adsorption, were characterized. The adsorbed amount of fibrinogen decreased with an increasing percentage of chitosan in the films, which predominantly showed an inverse correlation with surface hydrophilicity. Similarly, the initial cell sedimentation after 1 h resulted in lesser cell deposition as the chitosan ratio increased in the film. Furthermore, the QCM-D signal patterns, which were measured on the homopolymer and blend films during the first 18 h of cell adhesion, also showed an influence of the different interfacial properties. Cells fully spread on pure PCL films and had elongated morphologies as monitored by fluorescence microscopy and scanning electron microscopy (SEM). Corresponding QCM-D signals showed the highest frequency drop and the highest dissipation. Blend films supported cell adhesion but with lower dissipation values than for the PCL film. This could be the result of a higher rigidity of the cell-blend interface because the cells do not pass to the next stages of spreading after secretion of their extracellular matrix (ECM) proteins. Variations in the QCM-D data, which were obtained at the blend films, could be attributed to differences in the morphology of the films. Pure chitosan films showed limited cell adhesion accompanied by low frequency drop and low dissipation.

The Correlation Between Fibronectin Adsorption and Fibroblast Cell Behaviors on Chitosan/Poly(ϵ-Caprolactone) Blend Films

Preparation and properties of chitosan/poly (ε-caprolactone) blend films

Protein Adsorption Behaviors on Chitosan/poly(ɛ-Caprolactone) Blend Films Studied by Quartz Crystal Microbalance with Dissipation Monitoring (QCM-D)

Monitoring Cell Adhesion on Polycaprolactone-Chitosan Films with Varying Blend Ratios by Quartz Crystal Microbalance with Dissipation

Chitosan Functionalised Poly(ε-Caprolactone) Nanofibrous Membranes As Potential Anti-Adhesive Barrier Films

A Quantitative Study of MC3T3-E1 Cell Adhesion, Morphology and Biomechanics on Chitosan–collagen Blend Films at Single Cell Level

Studies on biological properties of chitin/carboxymethyl chitosan/hydroxypropylated chitosan blend films for preventing adhesion

The Behavior of Mc3t3-E1 Cells on Chitosan/Poly-L-Lysine Composite Films: Effect of Nanotopography, Surface Chemistry, and Wettability

Studies on the Properties of Three Kinds of Blend Films as Corneal Endothelial Cell Carrier

Immobilization of fibronectin in chitosan substrates improves cell adhesion and proliferation

A Correlation Study of Protein Adsorption and Cell Behaviors on Substrates with Different Densities of Peg Chains

Effect Of Fiber Structure On The Properties Of The Electrospun Hybrid Membranes Composed Of Poly(E-Caprolactone) And Gelatin

Kinetics and isotherm of fibronectin adsorption to three-dimensional porous chitosan scaffolds explored by ¹²⁵I-radiolabelling

The correlation between fibronectin adsorption and attachment of vascular cells on heparinized polycaprolactone membrane.

Structure, morphology and cell affinity of poly(L-lactide) films surface-functionalized with chitosan nanofibers via a solid-liquid phase separation technique.

Surface Properties of Chitosan Films Modified with Polycations and Their Effects on the Behavior of Pc12 Cells

Chitosan Surface Modified Electrospun Poly(ε-Caprolactone)/carbon Nanotube Composite Fibers with Enhanced Mechanical, Cell Proliferation and Antibacterial Properties.

Adsorption of Fibronectin on Salt-Etched Polyelectrolyte Multilayers and Its Roles in Mediating the Adhesion and Migration of Vascular Smooth Muscle Cells.

Biocompatibility of Poly(ε-caprolactone) Scaffold Modified by Chitosan—The Fibroblasts Proliferation in Vitro

Electrospun Chitosan-P(lla-cl) Nanofibers for Biomimetic Extracellular Matrix.

Characterization of the surface biocompatibility of the electrospun PCL-collagen nanofibers using fibroblasts