Abstract:With a large number of distributed generation connected to the distribution network, the total supply capacity of the distribution network has been improved to a certain extent. However, due to the randomness of its output, it also brings some challenges to the reliable operation of the distribution network and the restoration of power supply after failure. Based on this, this paper proposes an active distribution network reconfiguration strategy with uncertain factors for maximum total supply capacity improvement. Firstly, the evaluation index of the maximum total supply capacity of distribution network is constructed, and the maximum total supply capacity index under the current operation mode is evaluated online through the calculation model of maximum total supply capacity based on N-1 security criterion. Then, the uncertainty of wind power, photovoltaic and electric vehicle DG and the stochastic model of prosumer load are considered, random variables are generated by Latin hypercube sampling (LHS) and their correlation is considered. Then, it introduces that the position of sectionalizing switch and tie switch can be adjusted according to the dispatching demand. Based on the evaluation index of maximum total supply capacity and DG output of uncertain factors, the active reconfiguration model of distribution network after fault is proposed. Finally, a calculation example illustrates the effectiveness and correctness of the model in this paper. It is demonstrated that the model can optimize the selection strategy of Section switch and tie switch after the fault of distribution network, improve the utilization rate of distributed energy, and give full play to the power supply recovery potential of distribution network and reduce the outage time of prosumer groups.

Study on Weak Link for Distribution Network Based on Total Supply Capability

A Path-Based Method for Feeder Partition Available Capability Evaluation under N-1 Security Criterion

A Method to Evaluate Total Supply Capability of Distribution Systems Considering Network Reconfiguration and Daily Load Curves

Total supply capability model for distribution network with electric trading market

Total Supply Capability (TSC): A approach to formulate security and efficiency of distribution systems

A TOPSIS-Based Vulnerability Assessment Method of Distribution Network Considering Network Topology and Operation Status

Identification of Vulnerable Lines in Power Grid Considering Relative Probability and Consequence of Line Outage

Design Of Weak Link Identification System For Power Grid Based On Topology Analysis And Association Set Decomposition

Study on Power Exchange Node and Its Application

AN IMPROVED ALGORITHM SOLVING FAULT LOCATION AND ISOLATION OF A SPECIAL DISTRIBUTION NETWORK CONNECTION

The influence mechanism of substation transformer on total supply capability (TSC) of distribution networks

Study on Fundamental Principles and Methodologies of Distribution Network Reconfiguration

Critical links and nonlocal rerouting in complex supply networks

Reinforcement of Topologically Weak Power Networks Through Network Structural Characteristics Theory

Research on low voltage distribution network topology generation method based on “transformer - distribution box - meter box - meter” model

Power Supply Reliability Assessment Including Island Division and Network Reconfiguration

Fault Reconfiguration Strategies of Active Distribution Network With Uncertain Factors for Maximum Supply Capacity Enhancement

Optimization of Distribution Network Reconfiguration Based on Markov Chain Monte Carlo Method

Security Evaluation under N-1 for Distribution Network Based on Load Restoration Strategies

Study of algorithm on distribution network optimum reconfiguration for reducing line loss

Topology Modeling Method for Distribution Network via Power Line Communication