Abstract:NiO nanomaterials prepared using a solid–liquid NH3·H2O precipitation method (NiO-NSL) were tested in the catalytic combustion of methane. The NiO-NSL presented a characteristic rod-like nanostructure with a length of about a few hundred nanometers except for a part of the nanoparticles. For comparison, the NiO nanomaterials prepared by the traditional liquid-phase NH3·H2O precipitation method (NiO-NLL) were tested in the same reaction conditions. NiO-NSL exhibited significantly higher methane combustion activity than NiO-NLL and achieved the complete combustion of methane at 390 °C, which was outstanding in non-noble metal-based catalyst. X-ray photoelectron spectroscopy (XPS) and hydrogen-temperature-programmed reduction (H2-TPR) results indicate that the surface Ni2+ content of NiO-NSL was higher than that of NiO-NLL, and the presence of more Ni2+ might be responsible for the enhanced activity. DFT calculations prove that the energy barrier for C–H bond activation on Ni2+ was lower than that on Ni3+, which was consistent with the higher methane catalytic combustion activity of NiO-NSL. In addition, when the precipitating agent was replaced with NaOH and (NH4)2CO3, the generalization of the solid–liquid precipitation method in the preparation of the NiO catalysts was also tested. The results show that the solid–liquid precipitation method proposed in this work was still applicable when NaOH was used as a precipitant. However, with the use of (NH4)2CO3 as a precipitant, the methane catalytic activity of the NiO nanoparticles prepared by the solid–liquid precipitation method was reduced to a certain extent compared with the traditional liquid-phase precipitation method. This research can open up a highly efficient and environmentally friendly method for the synthesis of methane combustion catalysts.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.1c00732?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.1c00732</a>.Stability test results of NiO-NSL (Figure S1); wide-angle XRD patterns of the as-precipitated samples using (NH4)2CO3 as the precipitant and a standard xNiCO3·yNi(OH)2 sample (Figure S2); representative TEM images of the precursors and as-calcined catalysts of the other four samples (Figures S3 and S4); specific performance data of samples in previous research (Table S1); XPS analysis of the other samples (Table S2, Figures S5 and S6); H2-TPR profiles of the other samples (Table S3, Figures S7 and S8); detailed DFT calculation results (Table S4); the surface model used in the calculations (Figure S9) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.1c00732/suppl_file/an1c00732_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Systematic Study of Detonation Synthesis of Ni-based Nanoparticles

Size- and Structure-Controlled Synthesis and Characterization of Nickel Nanoparticles

PREPARATION OF NiO NANOPARTICLES ON THE SILICA SURFACE BY ADSORPTION PHASE SYNTHESIS AND ITS REGULATION ON MORPHOLOGY OF NiO PARTICLES

Experimental Study on Synthesis of Nio Nano-Particles

Characterization and Mechanism Elucidation of Nano-TiO2 Composites Prepared by Gaseous Detonation Method

Eruption Combustion Synthesis of NiO/Ni Nanocomposites with Enhanced Properties for Dye-Absorption and Lithium Storage.

Chemical Synthesis of Monodisperse Fe-Ni Nanoparticles Via A Diffusion-Based Approach

Controllable Synthesis of Carbon Coated Iron-Based Composite Nanoparticles

Preparation of Hollow Carbon Nanospheres Via Explosive Detonation

Synthesis of Ni Nanoparticles and Their Catalytic Effect on the Decomposition of Ammonium Perchlorate

Chemical and Laser Ablation Synthesis of Monometallic and Bimetallic Ni-Based Nanoparticles

Preparation of a nanoscale homogeneous energetic lead azides@porous carbon hybrid with high ignition ability by in situ synthesis

Study on the Preparation and Catalytic Characteristics of Nano-Nickel Powder

In Situ Thermal Atomization to Convert Supported Nickel Nanoparticles into Surface‐Bound Nickel Single‐Atom Catalysts

Synthesis, Characterization of Multiangular Nickel Nanoparticles and its Photocatalytic Properties after Loaded TiO2

Conversion of Conventional NiO Powders into Nanostructures by a Simple Chemical Method

Formation Mechanism for Oxidation Synthesis of Carbon Nanomaterials and Detonation Process for Core-Shell Structure

Irregularly Shaped NiO Nanostructures for Catalytic Lean Methane Combustion

Spark Ablation Generation of Metal Nanoparticles and Coating on TiO2 in the Aerosol Phase

Synthesis and Properties of Nanostructured Mg<sub>2</sub>Ni-Based Compounds

Nickel Nanoparticles: Insights into Sintering Dynamics