Abstract:In the last few years, broadband and switchable frequency selective surfaces (FSSs) absorber/reflector are of great importance in different areas such as stealth system, EM interference, EM compatibility, and so on. In this paper, to obtain a switchable frequency selective surfaces absorber/reflector in different states, a broadband and switchable absorber using an absorb/reflective FSS is presented. The top layer of the proposed switchable absorber is a periodic arrangement of square loops loaded with PIN diodes on a dielectric substrate which has a sufficient mechanical strength to hold up all the units, and under the square loops there are honeycomb of a certain thickness and a thin layer of metal. The structure has been characterized with the full-wave analysis and shows good absorption/reflection switching performance. Intrinsic impedance of proposed structure has also been investigated to explain the switching and the broadband absorption mechanisms of the structure. The working frequency band of the switchable absorbing structure is 2.5 ~ 5.5 GHz, and it switches states by changing the bias voltage. Biasing at different voltages to turn ON and OFF the diodes, the FSS structure can switch freely between absorption and reflection state. In ON state, the switchable FSS has two states working as a wideband absorber and the reflectivity in 2.5 ~ 5.5 GHz is below -10 dB, while in OFF state it has fine reflective property. In addition, inductances are used to connect each element of the structure to achieve the purpose of broadband isolation. Simulation and measurement results demonstrate the performance of the proposed structure.

Optimal design of electromagnetic absorbers using visualization method for wideband potential applications

New graphic method design of wideband frequency selective surfaces embedded within dielectric layers

Flexible Design and Realization of Wideband Microwave Absorber with Double-Layered Resistor Loaded FSS

Thin and Broadband Electromagnetic Absorber Design Using Resistors and Capacitors Loaded Frequency Selective Surface

Design of a Dual-Band Electromagnetic Absorber with Frequency Selective Surfaces

Flexible and conformable broadband metamaterial absorber with wide-angle and polarization stability for radar application

Broadband and Omnidirectionally Matched Absorber for a Discrete Source

Design of a Broadband and Switchable Absorber Using an Absorb/Reflective FSS

Analysis FSS Absorber with Diversified Impedance for Broadband Applications

A Broadband Metamaterial Absorber Design Using Characteristic Modes Analysis

Ultrabroadband Double-Sided and Dual-Tuned Active Absorber for UHF Band

Ultra-wideband Passive Double-Layer Absorber Design from the Reflective Point

An Ultra-Wideband Metamaterial Absorber With Active Frequency Selective Surface

Design of an Adjustable Polarization-Independent and Wideband Electromagnetic Absorber

Robust Design of Electromagnetic Wave Absorber Using the Taguchi Method

Analysis and Design of a Broadband Absorber Using Resistive Frequency Selective Surface

Design of a Thin Wide-Band Absorber Based on Metamaterials and Resistance Frequency Selective Surface

Ultrawide Bandwidth Electromagnetic Wave Absorbers Composed of Double-Layer Frequency Selective Surfaces with Different Patterns.

Fast Design of Ultra-Wideband Absorbers Based on Equivalent Circuit Model

On the Design of Wideband Absorber Based on Multilayer and Multiresonant FSS Array

Design of ultra wide-bandwidth double-layer electromagnetic wave absorbers with square-loop frequency selective surfaces