Abstract:The efficient crack eliminated stop-hole measure was proposed to repair and reduce the stress concentration associated fracture risk of the corrugated plate girders by setting it at the critical joint of flange plate with tightened bolts and gaskets under preloading. To investigate the fracture behaviour of these repaired girders, parametric finite element analysis was conducted, focusing on the mechanical feature and stress intensity factor of crack stop-hole in this paper. The numerical model was verified against experimental results first, and then the stress characteristics due to the presence of crack open-hole were analysed. It was found that the moderate-sized open-hole was more effective than the over-sized open-hole in the reduction of stress concentration. For the model with prestressed crack stop-hole through bolt preloading, the stress concentration was nearly 50% with the prestress around open-hole increased to 46 MPa, but such a reduction is inconspicuous for even higher prestress. Relatively high circumferential stress gradients and the crack open angle of oversized crack stop-holes were decreased owing to additional prestress effects from the gasket. Finally, the shift from the original tensile area around the edge of the crack open-hole that was prone to fatigue cracking to a compression-oriented area is beneficial for the reduction of stress intensity factor of the prestressed crack stop-holes. It was also demonstrated that the enlargement of crack open-hole has limited influence on the reduction of stress intensity factor and crack propagation. In contrast, higher bolt prestress was more beneficial in consistently reducing the stress intensity factor of the model with the crack open-hole, even containing long crack.

Residual Ultimate Strength of Open Box Girders with Cracked Damage

Residual ultimate strength of cracked box girders under torsional loading

Ultimate Torsional Strength of Cracked Stiffened Box Girders with a Large Deck Opening

Research on the residual ultimate strength of cracked box girder subjected to torsional load

A Modified Coffin-Manson Model for Ultra-Low Cycle Fatigue Fracture of Structural Steels Considering the Effect of Stress Triaxiality

Residual Torsional Strength of Cracked Stiffened Girders with A Large Deck Opening

Residual ultimate strength of stiffened box girder with coupled damage of pitting corrosion and a crack under vertical bending moment

Evaluation of Main Code Models for Predicting Flexural Load-Bearing Capacity Against Intermediate Crack-Induced Debonding in Frp-Strengthened Rc Beams

Improved Ultra-Low Cycle Fatigue Fracture Models for Structural Steels Considering the Dependence of Cyclic Damage Degradation Parameters on Stress Triaxiality

Ultimate Strength of the Circular Tubular X-joints

Assesment of Main Models for Predicting Debonding Load-Bearing Capacity Against Intermediate Crack-Induced Debonding Failure in Frp-Strengthened Rc Beams

Cracking Mechanism and Simplified Design Method for Bottom Flange in Prestressed Concrete Box Girder Bridge

CRACK MODEL OF REINFORCED CONCRETE BASED ON STRAIN DECOMPOSITION METHOD

Ultimate Tensile Strength Analysis of Rectangular Plate with Center Through-thickness Crack

Numerical Analysis of Fracture Behaviour for Cracked Joints in Corrugated Plate Girders Repaired by Stop-Holes

Application of Smeared Cracking and Damaged Plasticity Models in FEA of CFT

Residual Ultimate Strength of Hull Structures with Crack and Corrosion Damage

A Semi-Empirical Deflection-Based Method for Crack Width Prediction in Accelerated Construction of Steel Fibrous High-Performance Composite Small Box Girder.

Ultimate strength of stiffened panels with a crack and pits under uni-axial longitudinal compression

Ultimate Strength Characteristic and Assessment of Cracked Stiffened Panel under Uniaxial Compression

A New Flexural Strength Model of CFRP-strengthened RC Beams with Intermediate Crack Induced Debonding Failure