Abstract:Microchannels are widely used for heat transfer enhancement. The pressure characteristics are one of the most important factors affecting the heat transfer performance, and the pressure regulation may also control the heat transfer precisely in turn. As a common flow pattern of two-phase flow, slug flow has obvious advantages for heat and mass transfer, like steady flow rate and large interface area etc. Due to the interface stress and the velocity difference between the continuous phase and the dispersed phase, pressure fluctuations occur in both the flowing direction and the cross section. In oil and natural gas industries, pressure fluctuations of slug flow can be used for the slug size and velocity measurement, and also to analyze the principle of slug generation. However, when it comes to micro scale, pressure fluctuations of slug flow in microchannels is difficult to measure, not only due to the pressure difference within a low pressure range (10 to 103 Pa), but also because of the small size, for which conventional pressure sensors cannot be utilized. In this paper, a numerical method is adopted for the liquid-liquid slug flow (butanol/water) pressure prediction in a cross-junction square microchannel. To begin with, the validation of the numerical method is carried out by comparing the slug size with experiments under the same working conditions. Then, both pressure fluctuations in the flow direction and in the cross section are investigated. With a transient flow model, pressure fluctuations in the cross section at different flowing time are observed. Finally, effects of the dispersed phase (butanol) injection velocity on pressure fluctuations are performed. This work can be used for further study of the slug generation in microchannels. (Less)

Mass transfer characteristic in the formation stage of gas-liquid segmented flow in microchannel

Liquid-liquid Two-Phase Flow and Mass Transfer in T-shaped Micro-Channel Network

Mass transfer performance of gas-liquid segmented flow in microchannels

Slug Formation Analysis of Liquid–Liquid Two-Phase Flow in T-Junction Microchannels

PRESSURE FLUCTUATIONS OF LIQUID-LIQUID SLUG FLOW IN CROSS-JUNCTION SQUARE MICROCHANNELS

Gas–liquid–liquid Slug Flow and Mass Transfer in Hydrophilic and Hydrophobic Microreactors

Remarkable improvement of gas–liquid mass transfer by modifying the structure of conventional T‐junction microchannel

Hydrodynamics and Local Mass Transfer Characterization under Gas–liquid–liquid Slug Flow in a Rectangular Microchannel

Mass transfer characteristics of bubbly flow in microchannels

Experimental Investigation on Submerged Gas-Liquid Mixture Injection into Water Through A Micro-Channel

Mass transfer mechanism and relationship of gas–liquid annular flow in a microfluidic cross-junction device

Bubble/Droplet Formation and Mass Transfer During Gas-Liquid-Liquid Segmented Flow with Soluble Gas in A Microchannel

Mass transfer behavior of liquid-liquid slug flow in circular cross-section microchannel

Mass Transfer Phenomena Of Partially Miscible Liquids Under Liquid-Liquid Slug Flow In A Circular Microchannel

The Flow Pattern and Mass Transfer of Gas-Liquid-Liquid Three Phase Flow in Microchannel

Numerical investigation of mass transfer behavior of a gas–liquid two‐phase Taylor flow in a microchannel by a volume‐of‐fluid multiphase flow system

Investigation on Pressure Drop Characteristic and Mass Transfer Performance of Gas–liquid Flow in Micro-Channels

Distribution and Mass Transfer of Gas–Liquid Two-Phase Flow in Comb-Shaped Microchannels

Liquid-Liquid Two-Phase Flow Patterns and Mass Transfer Characteristics in a Circular Microchannel

Experimental investigation of two-phase slug flow splitting at a micro impacting T-junction

Hydrodynamics and Mass Transfer Performance of Gas–liquid Microflow in Viscous Liquids