Abstract:Nickel-rich layered LiNi1−x−yCoxMnyO2 (LiMO2) is widely investigated as a promising cathode material for advanced lithium-ion batteries used in electric vehicles, and a much higher energy density in higher cut-off voltage is emergent for long driving range. However, during extensive cycling when charged to higher voltage, the battery exhibits severe capacity fading and obvious structural collapse, which leads to poor cycle stability. Herein, Sn-doping and in situ formed Li2SnO3 nano-coating layer co-modified spherical-like LiNi0.5Co0.2Mn0.3O2 samples were successfully prepared using a facile molten salt method and demonstrated excellent cyclic properties and high-rate capabilities. The transition metal site was expected to be substituted by Sn in this study. The original crystal structures of the layered materials were influenced by Sn-doping. Sn not only entered into the crystal lattice of LiNi0.5Co0.2Mn0.3O2, but also formed Li+-conductive Li2SnO3 on the surface. Sn-doping and Li2SnO3 coating layer co-modification are helpful to optimize the ratio of Ni2+ and Ni3+, and to improve the conductivity of the cathode. The reversible capacity and rate capability of the cathode are improved by Sn-modification. The 3 mol% Sn-modified LiNi0.5Co0.2Mn0.3O2 sample maintained the reversible capacity of 146.8 mAh g−1 at 5C, corresponding to 75.8% of its low-rate capacity (0.1C, 193.7mAh g−1) and kept the reversible capacity of 157.3 mAh g−1 with 88.4% capacity retention after 100 charge and discharge cycles at 1C rate between 2.7 and 4.6 V, showing the improved electrochemical property.

The Improvement of the High-Rate Charge/discharge Performances of LiFePO 4 Cathode Material by Sn Doping

Effects of Tin Doping on Physicochemical and Electrochemical Performances of LiFe1−xSnxPO4/C (0≤x≤0.07) Composite Cathode Materials

Electrochemical Properties of Sn-doped Li3V2(PO4)3 Cathode Material Synthesized Via a Citric Acid Assisted Sol–gel Method

Sn-doped Li1.2Mn0.54Ni0.13Co0.13O2 cathode materials for lithium-ion batteries with enhanced electrochemical performance

Improvement Of Lifepo4 Electrochemical Performance By Doping Metal Oxides

Mitigation of Cation Mixing of LiNiO2-based Cathode Materials by Li-doping for High-Performing Lithium-Ion Battery

Spinel LiMn2O4 integrated with coating and doping by Sn self-segregation

In situ doping of lithium iron phosphate with excellent water-soluble zinc salt was used to improve its magnification performance

Facile synthesis of Fe-doped Sn4P3 anode materials for high-performance lithium-ion batteries

Improving the Electrochemical Performance of Lifepo4/C by Doping Magnesium Trisilicate

Investigation on the structure and electrochemical performance of LiNi0.8Co0.1Mn0.1O2 modified with Sn

Sn(II,IV) steric and electronic structure effects enable self-selective doping on Fe/Si-sites of Li2FeSiO4 nanocrystals for high performance lithium ion batteries

Stannum Doping of Layered Lini3/8co2/8mn3/8o2 Cathode Materials with High Rate Capability for Li-Ion Batteries

Influence of Lanthanum Doping on Performance of LiFePO4 Cathode Materials for Lithium-Ion Batteries

Enhancing electrochemical performance of Mn doped LiFePO4 cathode materials for lithium-ion batteries

B-Mg Co-Doping Behavior of LiFePO4 Cathode Material: Balance of Oxygen Vacancy and Enhancement of Electrochemical Performance

Sn-Doping and Li2SnO3 Nano-Coating Layer Co-Modified LiNi0.5Co0.2Mn0.3O2 with Improved Cycle Stability at 4.6 V Cut-off Voltage

Profiting the Co-Modifications of Li 2 SnO 3 Coating and Sn 4+ Doping in Co-Free Ni-Rich Cathode Particles for Lithium-Ion Batteries

Electrochemical Performance of LiMnPO4 by Fe and Zn Co-Doping for Lithium-Ion Batteries

Synthesis and Electrochemical Properties of Molybdenum-Doped LiMn0.6Fe0.4PO4 Cathode Materials

A novel Cu+-doped Li[Fe0.9Cu0.1Li0.1]PO4/C cathode material with enhanced electrochemical properties