Abstract:A multi-frequency locally resonant (LR) phononic plate is proposed in this paper. The phononic plate consists of periodic arrays of multiple double-cantilevered thin beams attached to a thin homogeneous plate. This proposed phononic plate is simplified and modeled using a plane wave expansion method to enable the calculation of flexural wave band structures. The band gap behavior of the phononic plate is analyzed comprehensively. In addition, an experimental specimen is fabricated using a square aluminum plate with a thickness of 0.9 mm and an area of 840 mm840 mm, and attached to the specimens as periodic arrays of two types of double-cantilevered thin beams made of the same material as the host plate. And the specimen is measured by using a scanning laser Doppler vibrometer to verify the theoretical predictions of band gaps. Investigations of this paper yield the following findings and conclusions: (1) Due to the interaction of low-frequency vibrational modes of attached multiple double-cantilevered beams and flexural vibration of the host plate, the proposed multi-frequency LR phononic plate can exhibit multiple low-frequency flexural wave band gaps (stop bands). It is also found that the band gaps of a multi-frequency LR phononic plate, especially those appearing in a lower frequency range, are generally narrower than that of a single-frequency LR phononic plate with the same type of double-cantilevered beams. (2) The frequency location of band gaps moves to higher frequency range when the thickness of the double-cantilevered beams is increased, or when the length of the double-cantilevered beams is decreased. It is also shown that a very small variation of the thickness (e. g., 0.1 mm) may lead to significant changes of frequency position of the band gaps. (3) When the width of the double-cantilevered beams is enlarged or the number of the double-cantilevered beams is increased, the lower band gap edge will move to a lower frequency range, while the upper band gap edge will move to a higher frequency range. This implies that the bandwidth of the band gaps is broadened. However, at the same time, it is shown that the central frequencies of the band gaps remain almost unchanged. (4) Experimental measurements of the fabricated specimen evidence the existence of two low frequency band gaps, and confirm that the flexural plate vibrations are significantly reduced in the predicted band gaps.

One-Dimensional Bi-Stage Phononic Band Gap Shaft Structure for Reducing Torsional Vibration

Hybrid Method for Analyzing the Torsional Vibration of One-Dimensional Phononic-Band-Gap Shafts

Locally Resonant Band Gaps in Flexural Vibrations of A Timoshenko Beam with Periodically Attached Multioscillators

Analysis of Flexural and Torsional Vibration Band Gaps in Phononic Crystal Beam

A new periodic shaft model for broadband ultra-low-frequency vibration reduction in spinning shafts

Low-Frequency Bandgap Characterization of a Locally Resonant Pentagonal Phononic Crystal Beam Structure

Low-frequency band gaps in quasi-zero stiffness locally resonant metamaterial shaft

Ultra-low frequency broadband gap optimization of 1D periodic structure with dual power-law acoustic black holes

Extending and Lowering Band Gaps by Multilayered Locally Resonant Phononic Crystals

Large Band Gaps in Radial Phononic Crystal Structure with Round Mass Block

Vibration Band Gaps in Double-Vibrator Pillared Phononic Crystal Plate

Tunable and Large Gaps in A Two-Layer Semi-Ring Structure

Low Frequency Band Gaps and Vibration Reduction Properties of A Multi-Frequency Locally Resonant Phononic Plate

Analysis of Vibration-Damping Characteristics and Parameter Optimization of Cylindrical Cavity Double-Plate Phononic Crystal

Lamb waves propagation in a novel metal-matrix phononic crystals plate

Flexural vibration band gaps in a phononic crystal beam containing rotational resonators

Low-frequency Bandgaps of Two-Dimensional Phononic Crystal Plate Composed of Asymmetric Double-Sided Cylinder Stubs

Flexural–torsional vibration reduction of an eccentric phononic crystal pipe conveying fluid

A locally resonant phononic crystal structure with low-frequency broad bandgap

Flexural Vibration Band Gaps in a Double-Side Phononic Crystal Plate

Design of novel two-dimensional single-phase chiral phononic crystal assembly structures and study of bandgap mechanism