Abstract:Organometallically prepared AlH3 and as-received Al powders were mixed with MgH2 to improve the dehydriding and rehydriding properties of MgH2. Thermal analysis shows that the onset dehydriding temperature of MgH2 is reduced by 55 degrees C (or 25 degrees C) when mixed with AlH3 (or Al). The destabilization of MgH2 is attributed to the formation of Mg-Al alloys through the reaction between MgH2 and Al. Isothermal dehydriding measurements demonstrate that AlH3 and Al both improve the dehydriding kinetic of MgH2 to some extent, and it only takes 44 min for MgH2 + AlH3 (5.4 h for MgH2 + Al) to release 60% of the hydrogen of MgH2 at 300 degrees C, but 8.6 h are required for as-milled MgH2. The apparent activation energy for the dehydriding of MgH2 is reduced from 174.6 kJ mol(-1) for as-milled MgH2 to 154.8 and 138.1 kJ mol(-1) for MgH2 mixed with Al and AlH3 respectively; this is responsible for the improvement in the dehydriding kinetics of MgH2. Despite this, AlH3 is better in destabilizing MgH2 than the as-received Al for the fact that Al* formed in situ from the decomposition of AlH3 is oxide-free on the particle surfaces, which effectively increases the chemical activity of Al*. Furthermore, the brittleness of AlH3 makes it easier to mix MgH2 with AlH3, which would result in uniform distributions of Mg and Al and shortening of the diffusion length. Concerning the reversibility, at 300 degrees C and 5 MPa H-2 and MgH2 are fully recovered in the dehydrided MgH2 + Al, and MgH2 + AlH3 samples after rehydriding for 10 h. The rehydriding kinetic of MgH2 is significantly enhanced for the dehydrided MgH2 + AlH3, but not in the case of the MgH2 + Al.

The controllable hydrolysis rate for LaMg 12 hydride

The High Capacity and Controllable Hydrolysis Rate of Mg3La Hydride

Synergistic Effect of LiBH4and LiAlH4Additives on Improved Hydrogen Storage Properties of Unexpected High Capacity Magnesium Hydride

Production of Hydrogen Via Hydrolysis of Hydrides in Mg–La System

LiAlH4 As a “microlighter” on the Fluorographite Surface Triggering the Dehydrogenation of Mg(BH4)2: Toward More Than 7 Wt % Hydrogen Release below 70 °C

Controllable Hydrolysis Performance Of Mgli Alloys And Their Hydrides

The Effect of Particle Size on Hydrolysis Properties of Mg3La Hydrides

Enhanced Hydrolysis Properties and Energy Efficiency of MgH2-base Hydrides

Enhanced Hydrogen Generation Properties Of Mgh2-Based Hydrides By Breaking The Magnesium Hydroxide Passivation Layer

An Investigation on the Reaction Mechanism of LiAlH4–MgH2 Hydrogen Storage System

Hydrogen Generation from Mg–LiBH4 Hydrolysis Improved by AlCl3 Addition

In-situ X-ray diffraction analysis of hydrogen-induced LaMg12 phase decomposition

Improved Hydrogen Storage Properties of MgH2 by Ball Milling with AlH3: Preparations, De/rehydriding Properties, and Reaction Mechanisms

Promoting Catalysis in Magnesium Hydride for Solid-State Hydrogen Storage Through Manipulating the Elements of High Entropy Oxides

The hydrogen storage behavior of Mg3La and Mg3LaNi0.1

The effect of Ni and Al addition on hydrogen generation of Mg3La hydrides via hydrolysis

Exploration of hydrogen generation from an Mg-LiBH4 system improved by NiCl2 addition

The Hydriding and Dehydriding Properties of Some Multicomponent Rare-Earth Magnesium Alloys

Study on the Dehydrogenation Properties and Reversibility of Mg(Bh4)(2)-Alh3 Composite under Moderate Conditions

Controllable hydrogen generation behavior by hydrolysis of MgH2-based materials

Microstructure Evolution and Controlled Hydrolytic Hydrogen Generation Strategy of Mg-rich Mg-Ni-La Ternary Alloys