Abstract:Biocompatibility, particularly blood compatibility is the most important property required for biomedical materials. The improvement of blood compatibility is always an important research task for biomaterial research and development. It is an important way to develop biomaterials by constructing special molecules onto the proper mechanical material surface. Polyetherurethanes are widely used as biomaterials due to their good biocompatibility and mechanical properties. Nevertheless, their blood compatibility is still not adequate for the more demanding applications. The purpose of present study was to synthesis a novel nonthrombogenic biomaterial by modifying the surface of polyetherurethane. Ozone was used to introduce active peroxide groups onto polyetherurethane surface and graft polymerization of N, N-dimethyl-N-methacryloxyethyl-N-(3-sulfopropyl) ammonium (DMMSA), a sulfobetaine structure, onto the ozone activated polyetherurethane surface was conducted. The nonthrombogenic properties of grafted film were also studied. The grafted film was characterized by ATR-FTIR, XPS and contact angle measurement. The ATR-FTIR, XPS of the grafted PU film indicated that the graft polymerization did take place, the grafted PU film surface was covered with the DMMSA polymer. The grafting yields in different condition were studied. The grafting yields increased with the increase of the monomer concentration. Water absorption and contact angle showed that the hydrophilicity of the film had been improved greatly, and the hydrophilicity of the film increased with the grafting yield. The blood compatibility of the grafted films was evaluated by platelet adhesion in platelet rich plasma and scanning electron microscopy observation using PU film as the reference. No platelet adhesion was observed for the grafted films incubated for 60 min and 180 min, however, the ungrafted PU film was covered with platelet. The result of platelet adhesion experiment indicated that the PDMMSA chains could prevent platelet adhesion. That means this new material is expected to have potential biomedical applications.

Modification of Hydrophilic Property of Polypropylene Fiber Film with Water-Soluble Chitosan for Improvement of Blood Compatibility

Introduction of anticoagulation group to polypropylene film by radiation grafting and its blood compatibility

Introduction of Photocrosslinkable Chitosan to Polyethylene Film by Radiation Grafting and Its Blood Compatibility

Surface Modification of Polypropylene Film by Radiation‐induced Grafting and Its Blood Compatibility

A photochemical method for the surface modification of poly(vinyl chloride) with O-butyrylchitosan to improve blood compatibility

New Biocompatible Polypyrrole-Based Films with Good Blood Compatibility and High Electrical Conductivity

Various approaches to modify biomaterial surfaces for improving hemocompatibility.

Functionalization of Polypropylene with Chiral Monomer for Improving Hemocompatibility

Polypropylene modified with 2-hydroxyethyl acrylate-g-2-methacryloyloxyethyl phosphorycholine and its hemocompatibility

Surface Modification Using Photocrosslinkable Chitosan for Improving Hemocompatibility.

Introduction of O-Butyrylchitosan with A Photosensitive Hetero-Bifunctional Crosslinking Reagent to Silicone Rubber Film by Radiation Grafting and Its Blood Compatibility

Covalent immobilization of O-butyrylchitosan with a photosensitive hetero-bifunctional crosslinking reagent on biopolymer substrate surface and bloodcompatibility characterization.

New-Type Sulphonated Polymer Surfaces for Improving Blood Compatibility

Biocompatible Polypropylene Prepared by a Combination of Melt Grafting and Surface Restructuring

Hemocompatibility evaluation of polyurethane film with surface-grafted poly(ethylene glycol) and carboxymethyl-chitosan

Alkylpolyglycoside inducing poly (butylene terephthalate) non-woven graft copolymerization of chitosan

Preparation of polypropylene superhydrophobic surface and its blood compatibility.

Surface Modification of Silk Fibroin Films with Zwitterionic Phosphobetaine to Improve the Hemocompatibility

Blood Compatibility of Polyurethane Surface Grafted Copolymerization with Sulfobetaine Monomer.

Blood Compatibility of Chitosan Immobilized on Poly(Ethylene Terephthalate) Surface Modified by Plasma and Ultraviolet Grafting

Synthetic studies on blood compatible materials. VIII. Poly(ether-urethane) surface grafted with sulfo-ammonium zwitterion monomer activated by ozone