Catalytic carbonization of lignin for production of electrically conductive charcoal

Gang Xiao,Mingjiang Ni,Rui Xiao,Xiang Gao,Kefa Cen
DOI: https://doi.org/10.1166/jbmb.2012.1190
2012-01-01
Journal of Biobased Materials and Bioenergy
Abstract:Lignin, a waste produce of pulp mills, is the major feedstock for producing biomass charcoal of low electrical resistivity, a potential substitute for metals as electromagnetic shielding materials. In order to reduce the electrical resistivity of charcoal further, three carbonization modes were tested. For Mode 1, carbonization without catalyst, the electrical resistivity decreased from 2070 to 0.20 Omega . cm when the final temperature increased from 600 to 1400 degrees C. For Mode 2, catalytic carbonization with Fe-based catalyst pre-mixed with lignin, the electrical resistivity was higher than for Mode 1 due to catalyst contamination. For Mode 3, catalytic carbonization with Fe-based catalyst added to pre-carbonized lignin, the electrical resistivity was decreased to similar to 0.15 Omega . cm at 900 degrees C for a lignin:catalyst mass ratio of 1:10, with a pre-carbonization temperature of 400 degrees C. X-ray diffraction, scanning electron microscope and energy dispersive X-ray analyses indicated that the decrease in electrical resistivity was probably caused by formation of ultrafine graphite-like crystallites with the appearance of sodium compound crystals.
What problem does this paper attempt to address?