Abstract:Two problems exist in the study of the trajectory optimization problem of powered hypersonic gliding vehicles (HGVs) due to insufficient consideration of the overall design constraints as well as the strong couplings among relevant disciplines: (1) the engine and thrust models are not compatible with the existing HGV; (2) configuration parameters of the HGV are not included as design variables during trajectory optimization (i.e., propulsion discipline is decoupled in the process of the HGV configuration design), thus failing to fully explore the effect of power to improve the performance of the HGV. Therefore, the application of multidisciplinary design optimization (MDO) in the overall design of powered HGVs should be investigated. First, a MDO task analysis and a multidisciplinary model analysis are carried out for the powered HGV. Second, the multidisciplinary optimization problem is defined, and the couplings between disciplines of the powered HGV are analyzed so that a six-discipline model is established that is suitable for the overall design process, including the parameterized configuration geometry, aerodynamics, propulsion, mass properties, trajectory, and aerodynamic heat/thermal protection system (TPS). Finally, a surrogate model is used to replace the time-consuming accurate model, and numerical optimization examples verify the effectiveness of the method. The optimization results show that the method has a good convergence speed, which increases the gliding range of the optimized vehicle by 8.37%. In addition, by decoupling the propulsion discipline, the validation shows that the coupled propulsion discipline during the overall design can increase the range of the powered HGV by 3.87% compared to the powered HGV optimized with the decoupled propulsion discipline. The work done in this paper provides a new design idea for the overall design of a powered HGV.

Research of Modeling Method Based on Integrated Design for Airframe-Propulsion-Control of AHV

Multidisciplinary Design Optimization of Reentry-Powered Hypersonic Vehicles Based on Surrogate Model

Unsteady Flow Simulation of a Variable-Sweep Morphing Aircraft Coupled with Flight Control System

Flight-Propulsion Integration Dynamic Analysis and Adaptive Control of the Hypersonic Vehicle at Wide-Range Mach Numbers

A Rapid Method of Integrated Aeropropulsive Analysis for the Conceptual Design of Airbreathing Hypersonic Aircraft

L 1 Adaptive Control of a Generic Hypersonic Vehicle Model with a Blended Pneumatic and Thrust Vectoring Control Strategy

Control-Oriented Modeling For Hypersonic Vehicle Control

Integrated guidance and control of hypersonic flight vehicle with coordinated mission requirement and input constraint

Prescribed Performance Control of Air-breathing Hypersonic Vehicle with Propulsion System Constraint

Flexibility Analysis of a Tracking Control Method for Air-Breathing Hypersonic Vehicles

Virtual Simulation Framework Of Intelligent Autonomous Control For Hypersonic Vehicle

Dynamic Surface Control Designing and Simulation for Hypersonic Vehicle

Designing Backstepping Control System for Hypersonic Vehicle Based on Feedback Linearization

Autonomous reliable intelligent control design under condition monitoring mechanism: Applied to hypersonic flight vehicles

On Modeling and Control of a Flexible Air-Breathing Hypersonic Vehicle Based on LPV Method

A composite controller design using an adaptive internal type-2 fuzzy logic system and the fixed-time disturbance observer for an air-breathing hypersonic vehicle with a variable geometry inlet

Intelligent Control of Air-Breathing Hypersonic Vehicles Subject to Path and Angle-of-attack Constraints

A simulation-based approach to modeling component interactions during design of flapping wing aerial vehicles

Dynamics modeling and analysis of thrust-vectored V/STOL aircraft

Adaptive Compound Control of Air-Breathing Hypersonic Vehicles.

Dynamic Surface Control of Constrained Hypersonic Flight Models with Parameter Estimation and Actuator Compensation