Abstract:Rare earth (RE) doped yttria sesquioxide has been widely used as host materials for upconversion (UC) phosphors due to their high refractive index, wide band gap, and high melting point. Meanwhile, while fluoride matrices with low phonon cutoff energies exhibit stronger UC emissions, RE-doped oxides exhibit better thermal stability and higher thermal sensitivity when applied as optical temperature sensors. In this work, Sc3+ is substituted in RE-doped Y2O3 lattices to generate smaller cation sites, enhancing the crystal field and modifying the allowed optical transitions. Er3+ is used as a photoluminescent probe to study the effect of site position and symmetry on the UC performance. In comparison with the traditional hydrothermal method, Sc3+ is successfully incorporated into the Y2O3 lattice via the co-precipitation/molten salt method without segregating observed. The Judd-Ofelt analysis was applied to determine the local symmetry and efficiency changes. Sc was found to be able to improve the luminescence performances of Er in Y2-x Sc x O3 (YScO) hosts by adjusting the local symmetry level around the luminescent sites. The local symmetry level was reduced with less than 30 mol % of Sc doping concentration based on the changes in Ω2 values. Meanwhile, the YScO oxide was found to significantly improve the luminescence intensity and red-to-green ratio at a lower Yb3+ concentration (5 mol %) instead of a higher concentration (20 mol %) commonly used. This was attributed to an increased energy transfer between the closer Yb3+-Er3+ pairs. Overall, this work allows the spatial occupancy of luminescence centers in the metal oxide host materials to optimize the UC luminescence performance and develop a high-efficiency oxide material for high-temperature applications such as optical thermometry.

Effect of Er substituting sites on upconversion luminescence of Er 3+-doped BaTiO 3 films

Upconversion Luminescence Tuning of Er3+ Doped Barium Titanate

Chemical Combustion Synthesis and Up-Conversion Properties of Er3+ Doped Yb3Al5O12 Powder

Upconversion photoluminescence properties of Er 3+-doped Ba xSr 1-xTiO 3 powders with different phase structure

Upconversion photoluminescence and dielectric properties in Er 3+ and Yb 3+ co-doped Sr 4 La 2 Ti 4 Nb 6 O 30

Spectroscopic Properties Of Er3+/Yb3+ Co-Doped 50sio(2)-20al(2)O(3)-30caf(2) Glass And Glass Ceramics

Intense Upconversion Luminescence of Er3+/Yb3+ Codoped Oxyfluoride Borosilicate Glass Ceramics Containing Ba2GdF7 Nanocrystals

Preparation Process and Upconversion Luminescence of Er3+-Doped Glass Ceramics Containing Ba2LaF7 Nanocrystals

Upconversion Photoluminescence of Er-doped Bi$_{4}$Ti$_{3}$O$_{12}$ Ceramics Enhanced by Vacancy Clusters Revealed by Positron Annihilation Spectroscopy

Red, Green, Blue and Bright White Upconversion Luminescence of CaTiO3: Er3+/Tm3+/Yb3+ Nanocrystals

Upconversion photoluminescence of Er-doped Bi Ti O ceramics enhanced by vacancy clusters revealed by positron annihilation spectroscopy

Impact of Sc3+-Modified Local Site Symmetries on Er3+ Ion Upconversion Luminescence in Y2O3 Nanoparticles

Upconversion luminescence and ferroelectric properties of Er3+ doped Bi4Ti3O12-SrBi4Ti 4O15

Effect of ligand field symmetry on upconversion luminescence in heat‐treated LaBGeO 5 :Yb 3+ , Er 3+ glass

Effect of Er 3+ concentration on the upconversion luminescence of GdOCl:Er 3+ powders with excitation of 514.5 nm

Effects of Phase Structure on Up-Conversion Photoluminescence and Dielectric Performance in Er3+ Doped (bi0. 5na0. 5)Tio3-Batio3 Lead-Free Ceramics

Opposite Effect of Li+ Codoping on the Upconversion Emissions of Er3+-Doped Tio2 Powders

Upconversion Photoluminescence And Exafs Of Er3+ And Ho3+ Codoped With Li+ Ion

Crystalline-structure-dependent green and red upconversion emissions of Er3+–Yb3+–Li+ codoped TiO2

Opposite effect of Li + codoping on the upconversion emissions of Er 3+ -doped TiO 2 powders

Effect of Li+ and Er3+ Co-Doping on the Luminescence Properties of Ba2sio4:Eu