Abstract:To analyze the heat transfer characteristics of oil shale under different in situ pyrolysis methods from a microscopic perspective, a combination of experimental and simulation approaches was employed. Initially, high-temperature in situ pyrolysis experiments on single-fracture oil shale were conducted using high-temperature steam and electrical methods. Subsequently, micro-CT scanning technology was utilized to obtain digital rock cores under different in situ pyrolysis conditions. Finally, these digital rock cores were seamlessly integrated with COMSOL 6.0 to achieve numerical simulations of high-temperature steam convective heating and electrical conductive heating in the in situ state. The relevant conclusions are as follows: Firstly, during the in situ pyrolysis of oil shale with high-temperature steam convective heating, the overall temperature increase is uniform and orderly. Heat is conducted gradually from the pores and fractures to the matrix. The uneven distribution of pores and fractures causes an uneven temperature field, but no localized overheating occurs, which can effectively enhance the pyrolysis efficiency. Secondly, the heat transfer direction in electrical conductive heating is primarily inward along the normal direction of the heat source end face. The closer the section is to the heat source end face, the higher the rate of temperature increase. Within 1 s, the temperature rise at 100 μm (near the heat source end face) is 2.27 times that at 500 μm (near the farthest cross-section from the heat source end face). The heat transfer effect of high-temperature steam convective heating consistently surpasses that of electrical conductive heating. The Tc value initially increases and then decreases as pyrolysis progresses, reaching a maximum of 1.61331 at 0.4 s, but Tc remains greater than 1 throughout. Finally, in the initial stages of pyrolysis, the high-temperature region formed by conductive heating is superior to that of convective heating. However, once the heat carrier fluid flow stabilizes, the volume of the high-temperature region formed by convective heating grows rapidly compared to that of conductive heating. At 1 s, the volume of the high-temperature region formed by convective heating reaches 5.22 times that of the high-temperature region formed by conductive heating.

Study of quantum chemistry calculation simulation for the effect of electric field on the kerogen molecular decomposition

Numerical Simulation of Oil Shale Pyrolysis under Microwave Irradiation Based on a Three-Dimensional Porous Medium Multiphysics Field Model

ReaxFF Molecular Dynamics Study on the Microscopic Mechanism for Kerogen Pyrolysis

Reaction mechanism and kinetics of kerogen dehydrogenation and cyclization investigated by density functional theory

Theoretical Analysis of the Effect of Electrical Heat In Situ Injection on the Kerogen Decomposition for the Development of Shale Oil Deposits

Quantum chemical calculations for the H free radical chemisorption with different chain models during oil shale pyrolysis

Thermal dynamics in deep shale reservoirs: Influences of the kerogen microstructural behavior on the gas adsorption/desorption capacity

Structural model of Longkou oil shale kerogen and the evolution process under steam pyrolysis based on ReaxFF molecular dynamics simulation

Investigation of typical heterocyclic fragment structures and reaction characteristics in oil shale using density functional theory

Microstructural Imaging and Characterization of Oil Shale Before and after Pyrolysis

Numerical Investigation of the in Situ Oil Shale Pyrolysis Process by Superheated Steam Considering the Anisotropy of the Thermal, Hydraulic, and Mechanical Characteristics of Oil Shale

Comprehensive preparation and multiscale characterization of kerogen in oil shale

Numerical analysis of microwave-enhanced oil shale pyrolysis by rotation turntable based on the Arbitrary Lagrangian-Eulerian method

Multicomponent Shale Oil Flow in Real Kerogen Structures via Molecular Dynamic Simulation

Experimental Study on the Factors of the Oil Shale Thermal Breakdown in High-Voltage Power Frequency Electric Heating Technology

Sensitivity Analysis of Oil and Gas Production in the In Situ Pyrolysis of Oil Shale

Entropic control on the desorption of oil molecular droplets in water from kerogen surface

Kinetic modeling of Kukersite oil shale pyrolysis with thermal bitumen as an intermediate

Modeling study on effects of intraparticle mass transfer and secondary reactions on oil shale pyrolysis

Characterization of fracture and percolation processes in oil shale under conduction and convection heating modes based on micro-CT technology

Simulation Study on the Heat Transfer Characteristics of Oil Shale under Different In Situ Pyrolysis Methods Based on CT Digital Rock Cores